Outer Limits 4x4 Board

4.2ltr run 2.5'' with turbo muffler full flow.
4.2td ... run 3'' with new dump pipe 3'' hot dog muffler mandrel bent 3ltr .. 2.5'' with turbo tripple flow muffler.
4.5ltr and 4.8ltr 3'' mandrel bent 3'' super cat 3'' turbo trippel flow muffler
2.8ltr run 2.25'' turbo tripple flow

Mate the 4.2s like a bit of load and with the diff change and the bigger tyers dont be suprised if you feel it goes better with the bigger rubber. I had one in a GQ non turbo and when i put the boat on (16ft tinni) it pulled alot better but dont get to greedy as to much and you will kill it. Cheers ...

Mate the 4.2s like a bit of load and with the diff change and the bigger tyers dont be suprised if you feel it goes better with the bigger rubber. I had one in a GQ non turbo and when i put the boat on (16ft tinni) it pulled alot better but dont get to greedy as to much and you will kill it. Cheers ...

The way to tell if the bar is air bag compatable is to look at the mounts behind the front face of the bar, if you look at the end of the chassis of the car you will see that it has several small folds in the ends of them and this is the crush zone of the chassis. The bull bar will have an ...

Be careful fitting twin piston calapers if you only have singles now as the master cylinder cant handle the extra volume of fluid required for the job. Have fitted two upgrades to GQ comp trucks and both needed to fit the master cyl as they were pumping the peddle to get good brakes. The twin piston ...

The three litre does run a duel mass fly wheel and yes they can be machined, all they do is load up the flywheel and weld small tabs to it to hold it and then machine it when there finished they remove the tabs and your done. The only thing is that nine times out of ten the rubber bushes are u/s and ...

You will need plenty of oil pressure for the turbo the sdandard turbo taps into one of the small plugs under the exhaust manifold at the cam galleries in the side of the block.

Hey pootrol dont want to tell you this :cry: but the Nissan 4.2 petrol are renowned for doing the head gasket at the rear of the head right behind no six piston. There is two water gallerys there and there very close to the fireing ring on the gasket, if you are only useing the water you say you are ...

I supplyed a set for a comp truck we support and he fitted a GU front diff complet and rear centre all with 4.6ratio and we did him a very good price and donated $1500 of the purchase and it still cost him $1400 and he fitted them. Not many problems they fit under no probs but the GU diffs are a ...

If your looking for a good clutch to handle extra power and tyer sizes try the Dakin Safari Tuff Clutch or the All Terrain Clutch from clutch Induistries.
These are the best on the market at this time.

Hay i had a rd28 in my GU and when it gave up the gost i fitted a TD42 from an 03 GU and i still run the 4.6 gears and i run 35/12.5/15 pro comps and the speedo is about 4km/h out at 100ks, i could run slightly bigger tyres if i wanted and this would bring the gearing back to standard for the 4.2 ...

Hey i dont see what all the who har is,stage 5 ,when we got it straightened out was pretty good I thought, and as for the recovery side of things we had two vehicles there at both ends of the stage and both were needed.I think that the situation could have easily been resolved by firsly ensuring ...