Outer Limits 4x4 Board

Thanks DK

Hi DK funny you should say that about the pistons because I thought they looked a bit to squared off at the top and a bit close to the compression ring!!! If anyone has a 3.5ltre conrod they could measure or check the part # on it would be gr8 Thanks

Just found out the crank is a 4.4 leyland, by the number on crank. Still waiting on conrod info.

Hi Garry The engine is a Rangie motor it came complete with the heads and inlet manifold with the twin carbs. There is a Rangie on ebay at the moment with a 4.3 Stroker in it I might try him for info aswell. Cheers

OK markings on crank AYD0078 Which is cast in.
Markings on Conrods AC on one side on the other is
1 rod 602393 ST D 24 1 Rod 602393 ST SDF 67.
3 Rods 602393 ST SDF69 3 Rods 602393 ST SDF 68.
No markings on pistons. will measure stroke on the weekend. Cheers

Hi Loanrangie, I did notice there was no markings on the crank ( like 4.4 )
There is a number stamped on it i will get that tonight and post it here if that may help. I measured the stroke when I bought the motor and it was 90mm and figuring the nomal stroke is 71.12mm this added upto 4.4 but only ...

Hi all hope someone can shed some light on a 4.4Stroker motor I have.
I bought it in January this year it' a 3.5Rangie motor with a 4.4 crank.
Block and heads are in good condition just a hone and new bearing new cam and lifters but the pistons have two skirts broken off and look like they have been ...

I Have pm You my phone #'s Cheers

Sorry It's the bolt that holds the ball joint to the top diff houseing it has a washer and a split pin the nut size on mine is 30mm it hard to use a shifter big enough to tighten it up. I see your local at Pennenant hills if needed I have a 30mm ring spanner

Hi I have had the same prob I fittied a new adjustable ball joint about 2k k's later squeeking checked everything ended up being the castle nut had come loose thank god for the split pin. Tightened up all fixed for 2 weeks and started again took nut and washer off and the washer was deformed it is a ...

I have Maxxis Bighorns 255/85/16 on my rangie With 2.5" body lift and 1.5" spring lift with cut and flared guards.
I bought them 6000ks ago and find them real good on road good response a bit of noise at 100ks but you would expect that from a mud tyre. went out 2 weeks ago with them and let them ...