Outer Limits 4x4 Board

I've wondered how the 4.8 was on fuel ...My old '89 4.2 SWB maverick on petrol does the same on fuel 20 l to 100 kl = 1 litre per 5 kl'm and 2.5 litres per 5 kl'm off road ...Might update to a 4.8

1989 GQ 4.2 carby petrol engine. whilst driving around normally everything is great. But at idle it runs really rough, then stalls. I can keep it running at about 1300 rpm at traffic lights but runs rough. I'm sure it's a fuel problem but not quite sure what the cause is. Thought I'd ask if anyone ...

I have a Funnel that removes water , It's called Mr Funnel... It has some fancy filter thingy in it, made in th USA bought it from Burson for aprox $40 . an inexpensive Item to Guarantee no water getting in... :armsup: http://www.mrfunnel.com/What.html JUST MAKE SURE THERE IS NO WATER LEFT IN THE ...

There's an FICD actuator under the air filter box that lifts the ile speed when the air cond is on ...It's adjustable.

Get someone to switch the air con on & off and have a look under the air box firewall side . Hope this helps.

hey all, my td42 gq has a wierd dead knocking noise when it idles on a downslope with the handbrake on, or when i am reversing. i have replaced engine and gearbox mounts and all body mounts are fine. it's really stressing me out as i am now lost. Mate on your 1st post YOU had said that you REPLACED ...

what rear shock was it 92mav? When you first installed your springs, you said it all looked level. Did you actually take measurements? 1. Try disconecting your panhard rod front and rear, then take measurements. You may need to buy adjustable ones. or 2. Measure from the chassis to the ground. If ...

When you first installed your springs, you said it all looked level. Did you actually take measurements? 1. Try disconecting your panhard rod front and rear, then take measurements. You may need to buy adjustable ones. or 2. Measure from the chassis to the ground. If it's level (plus or minus 8mm ...

If you drive your truck hard you will constantly tear engine mounts, manufacture a new one by using a tube with shackle bushes and a bolt going through it so as it cannot tear, i have done this and it has lasted even through a double rollover the engine mounts still held up fine. I think cheezy ...

Thank you MYGQ..

Surely with the amount of left hand side engine mounts breaking on the GQs, I'd have a better response. C'mon fellas!

I've gone through the bible for info ..............rang cheezy but they no longer make engine mounts

Left hand side is the only one that keeps pulling apart Anyone else that makes them ? Or do I just get the original from Nissan.

Luca