Outer Limits 4x4 Board

Hey guys just wondering if anyone has a good mitsy mechanic on the goldcoast. Cheers

Thanks for your reply yom. The owner says its been rebuilt 55,000 k's ago to suit the blower and gas system so hope that rules out head issues. Its also got diff locks front and rear so can't wait to drive it!!

G'day fellas I've found a gq shorty that I'm thinking about buying. Its a supercharged tb42 running a straight gas research system. Just wondering if there's many problems associated with the gas with these engines and stuff to look out for when I go have a look at it. Any advice would be awesome ...

How much mate?

See one of the vids on that page of a dog wanking? Funny but a little weird.

Niced driving, especially around 1:19 I thought.

I got a pair of mangels for 40 each

Hey mechz, did you use aluminium or plastic blocks? How long did it take you. And last of all how'd you mod the fuel cap?
Cheers.Ash

Not bad. I reckon paj's would look real tough in a tray back ute set up. Anyone seen one?

I've bought a timing belt kit for my NH paj, can anyone tell me what the 3 seals I got in the kit are for? Cheers.

Is there a particular reason why you have limited yourself to those two vehicles?

Hey scott, I meant the bearing shells that go between the con rod and bearing cap on the piston had been completely grinded into shavings on two of the pistons.

Probably was a dodgy bros rebuild, the guy the boss bought the car off seemed a little shady!

Mate I'm also after a 2.6 as well for the triton at work. I've heard good and bad about this motor. The one I pulled out of our work car had grinded the bearing shells (from the pistons) to a fine paste in the bottom of the sump and sucked the shavings throughout the motor. Can't really say that hey ...

^^ Yep you do but with the manual hubs I'm pretty sure your diff, c.v's etc are not turning so you'd be saving wear n tear and fuel.

Awesome bitsamissan, just what I was after. I'm getting the lift kit off on boost engineering for $180 for 12 blocks and all new bolts and washers etc.
What do you guys reckon. I looked at that rockcrawler kits but couldn't be stuffed waiting for it to be shipped over.
Cheers.
Ash.

^^tough

^^cool thanks. will post pictures when its done.

Pull brake lines through the guard as you lift. Loosen the clamp on the steering shaft - it moves a little way as you lift. Have a look at mud flaps and fuel filler hose. I recommend one side at a time - leaves the body sitting on four points (shorty) or 6 points (LWB) at all times, instead of only ...

^^ Cheers for the reply mate I have a bull bar as well and have been told its a bit of a mission to re-install after the lift, is this true?
Also is there a need to get engineer certificate as I'll have 65mm suspension lift as well soon.
thanks again.
Ash

Hey all been newby here, I know this topic has been done to death but I'm after a step by step guide for body lifting a Nh paj with pictures. I know theres one on the very last page of this board and I've searched as well but all the links are dead, if any one could point me in the right direction ...