Outer Limits 4x4 Board

i more meant engine and under bonnet i dont mind doin wheel bearings and the like

just after some thoughts thanks [/i]

my boss got a slightly cheaper projecta compressor used it once it sat around for over a year went to use it again no pressure ie you can hold your finger over the air outlet rang projecta ( narva ) no parts avail he said if under warranty woukd get a new one

while we are on the boss compressor topic do they last under the bonnet of a 4wd

I don't know how much the tigerz rope is but it would be worth checking out Nobles for the cost of Supermax. From what i have seen and experienced the Supermax outperformed anything else and you could trust it. But you need to maintain any rope as the abrasion will make it more likely to wear out ...

well done barry and jim

hi just wondering where to get theese from as nissan dont sell them so they said

mite be battery on the way out or alternator to small or on its way out dont forget at 8000 pound load a highmount draws 450 amps

can u run 35's etc in road class

what was the end result ray

how hard is it to get 36 / 37 enginered on a gq in vic

as above need for a gq

thanks

according to an above post its right i just put a petrol safari clutch in and its great havent done heaps of kms yet prob done about 5000

also as above do the rear main seal and housing its cheap to do while ya there

BLACKBURN NISSAN

not sure how to check pre load the swivel bearings were replaced about 6 months ago



im leaning to wheel / tyres

as there was no shakes when i borrowed a set 3 days ago

as above i have the shakes around 60 to 80 area i have 6inch lift adj panhard rods with gen nissan bushes drop boxes radius arm bushes pretty much new gen nissan tough dot rtc cheezy drag link and tie rod both with new tie rod ends braced diff with new bearings etc 35 simex just put in 2 bags of ...

thanks for the replys sofar are they bush or hwy kms for the 4.2's

ive got a gq lwb 35 simex 4.6 gears just after some fuel economy figures for carby 4.2

thanks

i am replacing ridepro they lasted about 1.5 years

ive been havin a bit of a search need some shocks for my gq lwb 6inch spring what are the boss shocks that are on ebay like or any other suggestions would be great

thanks

just about to buy a new clutch was told the diesel one is the way to go my local parts shop rang exedy they said not a good idea he rang them 1 day later and a diffferent person said they are the same part number just searched the exedy web site the part number is 1 number different just after a ...

get a boss grande air compressor

im getting a 2 core with more open fin design is better for mud im told

can some one post some detailed pics of how they mounted the fans thanks

just found some info for ya http://www.ih8mud.com/tech/oldwarn.php

its a really old high mount i have seen them on usa ebay all the time there has been 1 that i have seen on ebay from vic

yeah i was thinkin about that or rhino lining

i mite just pull the gq body off and put a boat shell on rofl

i got some water in my gq on the weekend and pulled the carpet out

is there rubber or vinyl that i can put in

also has anyone had rhino linings spayed on there floor

thanks

yeah its the standard lights h4's yeah was planning to do some wiring