Outer Limits 4x4 Board

Cant see boost playing any part.

What was done in the tune, pump timing, injector pressures and extra fuel maybe responsible for the extra noise.

Doesnt sound good but i would check and make sure your pcv or breather is operating correctly or there is no blockages.

You would have to assume the 6hp would be more suited to a bigger/heavier 4wd.

Have you used the winch yet? Why not try it the way it is and if it doesn't suit look at upgrading then.

"bogged"so even after being told of all the dangers and shit, you still wanna do it just to have a "little look"....?
I recommend undoing the nut behind the wheel..

I think this statement is right on the money regarding alot of the questions asked here and other forums.

I've decided that half ...

Have a read through this topic on patrol4x4. He has done the same conversion and most of your questions have probably been asked and answered on there.


http://www.patrol4x4.com/forum/showthread.php?t=37212[/url]

Hey Z()ltan thats the price i got last night when i sent him a PM. How much did this cost for your setup.

Cheers, Shane

Maybe it was $1500 for the cooler itself?. If so you still need a large heat exchanger, pump, thermo's,water lines, fittings etc. It would quickly add up. I cant see you ...

Why not use a Auber digital gauge. I use one as my pyro and it is very responsive and also records high/low temps. It also allows you to run a alarm or a warning at a selected temp.

http://myworld.ebay.com/ebaymotors/auberinstruments

What is recomended if you are after a large 12v compressor? I messaged Probag about getting a boss px07 and they said they dont sell them anymore due to the amount coming back for warranty etc. Has anyone had problems with their boss compressors?

What about Viair, i was thinking of running two of ...

Are the bolt in braces available for a GU Coil ute? Front and rear. If so what are the part numbers so i can order.

Thanks

Simon

I would say these would be the same as this

http://www.allaircompressor.com/air-compressor-JD-126.htm

I had one which didnt last to long at all, replaced under warranty quickly and failed again within a week.

Maybe take some photos of the internals for people who are interested, pretty sure ...

I would try diff and or reduction gears before i looked at a conversion etc

Simon

Well bit of bad news today, I found where the waters going...

Its leaking out of the side of the head under the intake manifold. I am going to try and re-torque the head bolts to see if that will fix it. bit of a bummer since the engine still hasn't even done 1000ks yet :(

Its not coming from ...