Outer Limits 4x4 Board

got a photo of it?

heres mine

zzzz wrote:If anyone wants some bling switches these ones look very good

http://www.4x4mods.com/Product/Jeep/rockerswitches.html

bling bling

if the hammer wont do it, then get a bigger one, thats allways worked for me

heres the ones i made from my full doors..

someone must have some photos out there of tyre carirers

anyone have any photos of there swb fj40 rear bar?
wanting to make one and need ideas

pics of what it has to go on

has anyone got any ideas on a tyre carrier on a swb FJ40?

photos would be good

make it yourself, cant get cheeper than that

acording to toyota thay are 1998kg

well thats what thay say in there book

i got my warn xd9000 for free

TJM are good bars and very strong
easy to mount, (my last job was fitting them)

tjm's cradle is for thier alloy bars, i think, they are prolly just as good as each other, it all depends what you like the look of and how much u want to spend Alloy bars need cradles, but then again some of the steel bars also need then. depens on how the winch mounts inside,(feet forward or down)

check ya steering dampner,
had one that came into work doing that so we took it off and it stoped
then put a new one on and all was good

may not be the prob but worth a try at least

need to know spline count and size of tapered hole(top/bottom) of cruiser pitman arms
55#60#70#75#
any help will be good

do u know if the slaft on this pitman arm is the same as the crown one?

put a crown p/s box onto my fj40 (out front)

needing info on what i should do for steering slaft from cab to box
also what pitman arm to use as the crown one has a tayped pin on the end

easy as to install
like was said use a peice of rope
some times a bit of lube also helps it go in

more

center part is made from 6mm C setion and the rest of it 4mm

used a grinder and cutting wheel

1 more

more photos

what you need is the steering arms from a BJ43 HJ-FJ47 Cruiser ( have some of these arm sets on the shelf and are getting hard to get ) from about 1979 on as these have the correct bolt position for the later disc brake svivel housings. Alternatively you can get taper bushes to fit small 40 series ...

jake lawson wrote:arent the hilux and 60s rod ends the same size?

yep the taper is but the cruiser 40s and hilux tie rods are smaller than the 60s

may have to look at running 60s.70s or 75s rod as well but was hopeing there was a end that would fit into the 40s rod

i just posted on the other thread you made of this on the tech page can't you swap the fortys tie rod and replace it with a hilux? yes u can fit it on but the left tierod end is desined to take a steering dampner and not a relay rod so the taper is around the wrong way.. so need to find a tierod ...

all good then
have fun on those tracks again

fj40 with hilux disk brakes fitted
when to fit up tierod ends but the cruiser ones have a too small taper

what tierodend do u use ??
any help will be good as im pulling my hair out trying to get it sorted

4sum4 wrote:Don`t the 40s arms bolt on?

Nope
wish thay did

fj40 with hilux disk brakes fitted
when to fit up tierod ends but the cruiser ones have a too small taper

what tierodend do u use ??
any help will be good as im pulling my hair out trying to get it sorted