Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Search found 6 matches

by out&about
Wed Sep 28, 2011 8:28 pm
Forum: General Tech
Topic: Head machining
Replies: 3
Views: 353

Re: Head machining

Thanks mate this is the 3rd time it's been done I just want it done properly.
by out&about
Wed Sep 28, 2011 7:01 pm
Forum: General Tech
Topic: Head machining
Replies: 3
Views: 353

Head machining

Does anybody know a good place to get a tb42 head crack tested and repaired in north Brisbane ?
by out&about
Mon Aug 03, 2009 9:13 pm
Forum: Nissan
Topic: Laminating Rear Lower Control Arms
Replies: 49
Views: 3100

I put some angle on the bottom and flat bar on the top seems to be holding up quiet well has had a few hits so far but no damage yet
by out&about
Mon Aug 03, 2009 8:50 pm
Forum: Nissan
Topic: GQ wheel bearings
Replies: 4
Views: 421

Thanks guys, tried again tonight and had success was very tight but finally managed to get that dammed sirclip into its home :D
by out&about
Sun Aug 02, 2009 10:18 pm
Forum: Nissan
Topic: GQ wheel bearings
Replies: 4
Views: 421

GQ wheel bearings

Today I put new front bearings and sleeves into my gq 1994 patrol and when I put the new ones in I could not get the sirclip on once I had it all back together .I am wondering if the sleeves are a different width if any one else has had same problem would love some advice as to what I have done ...
by out&about
Tue Nov 13, 2007 7:31 pm
Forum: Nissan
Topic: floor pan knock
Replies: 37
Views: 8967

I have a GQ wagon that used to have the same noise all I did was get some teflon sheet and put that between body and body mount still allows a little bit of movement but there is no noise problem solvered :lol: