Outer Limits 4x4 Board

how bout sourcing some h/t M12 'fine' booker bar and making your own bolts (studs) up? It would probably be cheaper than $60, and you could cut it into what ever lengths you need

I stretched the coil out a bit for my 2" lift, worked ok for about 2years then got a fatigue crack in the middle of the simpson... not too fun.
I would suggest making up a new line to suit the bodylift and ensuring adequate flexibilty in the line and clearence.

oondy wrote:the larger washer needs to have 45mmOD-24mmID and the smaller washer 24mmOD-16mmID

both the same thickness obviously

cheers

OONDY

If you know someone with access to a lathe it's a 10-15min job

Make them yourself??? Its not that hard. Hardest part is finding the drawer runners & affordable fridge slides.

m12 bolts 118-127Nm
m8 bolts 16-21Nm

I bought my '89 GQ shorty td42 with an aftermarket kit allready fitted. The cable connected straight to the injection pump as you stated. The problem I had with it was, unless you were travelling on a flat section of h'way, the engine did not have enough power to stay in fifth gear with the cruise ...

I'm runniung 15 x 8 Toyota offset sunny's on my '99 DX td42. only just fit though.

I don't have a TB45. But I believe that you have to loosen the pivot point nuts on the aircon unit to allow it to rottate. Same goes for the Alt.

ouch!
sorry can't be of any help either.

Might be a stupid question but have you tried bleeding at the injector unions?