Outer Limits 4x4 Board

One other good thing about SHS is if you run it on edge i.e with the one corner down and one corner up, it will be allot more dent and kink resistant. Also when it comes to sold vs tube it is a balance. Solid bar kilo for kilo is no where near as strong as tube, but as said before tube can be dented ...

one other thing it could be is if you are running a vit air flow sensor, check to make sure that the big 3 inch hose clamps are not done up to tight. if they are to tight it can jam the sensor and not let it pop all they way back out on idle. This was the problem on one of my mates G16b, took as ...

has anyone ever had any problems with the sleeved section binding up or flaring. For exsample if the rear diff is at full drop and the tires grab tracion while the power is put down heavly, like going up a rock ledge.

that would be the case if it was a softtop

yea that is ture about zukes being as hard to break in to as a packet of smartys, but i think out of sight out of mind is allways a good security measure

I am in QLD and the cage will fall under a ladder rack / roof rack, I think I will just put a few stickers on saying such and such roof rack co. The main purpose of the cage/ ladder rack will be to protect against panel, window damage also occupant protection for small, slow hill roll over’s. I know ...

Just chasing a few people’s personal opinions, in the near future I plan to build an exo cage on to my 91 SWB hardtop sierra. But the thing I am debating is whether or not to take out my 2 inch body lift. The reason for this is I want to try and keep a low COG and with all that extra bar work I ...

It is hard to say how much it will cost for a tune but rough guide would be $600 to a $1000. But the thing other than the tune, ecu, supercharger and material cost will be the cost sorting out all your signal wires i.e. crank angle, tps, temp and airflow because as far as I know there are no plug ...

91 hard top
1.6 swift gti / vitara
old man emus removed lefs all round
2in body lift
31 federal muds on 15x8 by -24 off set
tube bar front
HD clutch
thermo fan 12in
http://img529.imageshack.us/img529/4172/imga0167tp1.jpg [/url]
http://img529.imageshack.us/img529/imga0167tp1.jpg/1/w1760.png [/img]

nice would you be able to post up informaion on how you did it mate

just a question, not sure if this is ture but i have been told that you can use parts from a swift twin cam dizzy and a sierra dizzy to make an angle drive all you need to do is a bit of Maching and pressing. If anyone has any info or knows wheather it is able to be done your input what be very ...