Outer Limits 4x4 Board

I made up a steel SHS subframe that bolted to the factory seat mounts in mine. The engineer said that if you wanted to weld plates in they had to be 100x100 (from memory so don't take it as gospel). I used a Suzuki Vitara seat that had the belts and buckles mounted to the actual seat unit. Fitted ...

Hey all,

I'm chasing information about putting a 2 person seat in the rear of my Fj40.

i need info about what kind of seat i can use, seat belt mounting etc.

all help will be muchly appreciated.

Thanks

Paul

HI ALL, I'VE AN FJ40 WITH 308, AND I'M HAVING ISSUES WITH THE CLUTCH DISENGAGING WHEN PUSHING PEDAL IN. IT TAKES ALL THE WAY TO THE FLOOR TO BE ABLE TO PUT IT INTO GEAR...... I ASKED A GUY AT WORK TODAY AND HE SAID I HAVE TO GET A DIFFERENT SLAVE CYLINDER TO THE STOCK FJ40 6CYL ONE I HAVE!!!! IS ...

You can try heli-coil which may be difficult if its a shallow blind hole but you could MIG weld the hole (less heat spread dont use arc) and re-drill and tap but you must measure the depth of the hole 1st and put masking tape around the drill bit at the required length so you dont go too far ...

have the threads from the bolts broken off in thereor has the bolts stuffed the threads in the block?

delete

delete

removed fuse and still no good. is there a way i can check directly at the gauge???



Cheers

does anyone know where i can either get a bikini top for my fj40 made up or some material to make one in Brisbane area???

i ran the battery cables along the chassis rail and also that's where the fuel sender wires are so maybe the joiner has come apart there possibly?
will check that first then check what gauge does when take the fuse out.

Cheers

gauge was working before i replaced fuse yes

hey sorry to interrupt thread. where abouts in Brisbane is that guy and approx how much for soft top?



Cheers

any one got any ideas?


cheers

poking and prodding and still no answer :(

delete

delete

delete

delete

delete

delete

delete

delete

delete

delete please

Yo_jono wrote:Hey Mate.

Have a Geez at this link, look Through and find the one on seatbelts.
I hope it helps ya, If not sorry for wasting your time.

http://www.infrastructure.gov.au/roads/ ... _ncop.aspx

Cheers
Jonathan

Cheers will do.

how thick is that roll bar,i reckon vacume cleaner tubes look thicker,are u sure its dot approved for seat belt mounting,i wouldnt go on what someones said,40 looks good though,good luck on finishing the beast off ha ha i like that one.. cheers for the compliment. I'ts a 308 4spd. lots of fun to be ...

no dramas will see what i can find out.

so.........i'm guessing either have them in a box in the back:) or bolted up and sharing same mounting points????? unsure.

where could i find out for sure.

bIg_ReD_bOiNs wrote:my understanding of the rules regarding harnesses on the road in QLD is that you can have them fitted but the OME seatbelts must be retained.

please explain how you mean "retained"? and forgive my stupidness.......... ome???

instead of stuffing around with the seatbelt on the rollbar way. can you fit an ADR approved harness eg; 4 point.......???

to the floor behind front seats.