Outer Limits 4x4 Board

I'm heading down with about 10 mates and the kids......4 or 5 nissan patrols.....Go the Patrols!!!!!!!!!!

Patrol ...one of the best drive trains.......

go all the way 270.2mm and only 2 foot long.. you will love it

Nice "madprk"


. Impressive
<When you take that front bolt out it makes a huge difference ..
nice flex

I have a MQ rear LSD fitted into my GU front centre and then fitted into my GQ front housing..
It didn't take much to do and its wound up very tight . Does alot of stuff lockers have to be turned on to do . And does it easy as.. Hasn't efected my turning circle to much and i dont break CVs or hubs ...

Not quite fully flexed but getting there!

On my other Patrol it had a leak and it was a 2 bolt plate on the side of the pump .
E asy as to undo and replace with a seal from nissan for $13 .

It looked bad at first but turned out to be an easy fix.

I'm in Brisbane and mine had a small leak. I was quoted $900 if i took the pump off myself , which is a very easy job on a 2.8 . Mine has no cable going to the pump just wires. GU. It can be done cheap. I was told to also do the timing belt while the jobs being done... :)

I would just knock some ...

allisterrenee wrote:
Make sure you put some oil on the seals and pistons when pushing them back into the calipers. This will help ...


Do Not Use Oil!!! It will swell the seals, use brake fluid only


Brake fluid is what i was trying to say ,sorry if i confused anyone , When i said oil , i ...

YES
Agreed

Only time will tell

Make sure you put some oil on the seals and pistons when pushing them back into the calipers. This will help ...

hey are they drum or disk?

I have LSD front and back wound up very tight and can do almost everything my mates do with lockers . Plus i dont have to turn them on or off . I think the GQ or GU LSD s are a great set up, with less drama's . I am building up my next truck now and might consider lockers but after hereing about the ...

When i have a clutch done the boys in the shop put silicon all the way around the bell housing and fill the drain hole in the bottom. Also put some around the rubber boot for the clutch fork , I can sit in deep water all the time with no probs and have been doing it for years, A really good 4wd shop ...

Hey . i had this trouble once. The resistance on each lead should be different . The longer the lead the more resistance. The shorter the less. check your number 6 lead and swap it with number 5 lead to see if its just the lead, Some times at night you can see the spark jumping from the lead , not ...