Outer Limits 4x4 Board

yeah its still the factory ecu and its running a fmic. iv tried shorting t1 and e and no fault codes come up so ill try t1 to ground and see if i can get any codes out. it was wired when i bought it but im not sure who did the work. Ive worked out that if you block the fuel return while cranking the ...

Ive nearly finished fitting a 1GGTE to my 86 4runner and was Just wondering if anyone has had much experience with the 1st gen 1GGTE engines? My problem is that i cannot get error codes from the motor by bridging t1 and E in the diegnostics plug. When the engine gets to full boost it cuts out ...

ive nearly finished fitting a 1ggte to my 86 4runner which i bought of a guy in melbourne who had it in his 85 single cab lux. if ur fitting it to an IFS hilux you will have to change engine mounts (bring them back 70mm) and sump to make it fit (see my pics) along with all the usual stuff involved ...

Look up your trans/axle code and go the next diff ratio down. eg, 4.88 drop to 4.56, 4.56 drop to 4.3.
Ive got 4.56 and 35's on my 4runner and it putts along fine on the highway.

just pull it appart and have a look. By the sounds of it there will be a problem with the bi directional valve. It may only need a simple clean up and recondition. A seal kit only costs about $60 from most 4wd parts suppliers.

im on holiday in thailand (koh samui) with my missus and ive seen a 90-93 hilux single cab (not that it matters) with a 5" lift. it is called "the unicorn suspension"and i looked it up but it is in a whack language. the link is listed below and it shows a pic of everything that included in the lift ...

I got a 4runner canopy off ebay for 99 cents which im going to chop into a bolt on ute back for the cab. Just wondering if anyone else has done this and if so how did u do it?

i have skyline r32 seats in my 86 4runner. 3 of the bolts line straight up, only one bolt needs an extender made up which is a piece of piss.