Outer Limits 4x4 Board

It isn't bottomed out...

Ill finish putting it all together and bleed it all out and see how it is.\

Thanks

Gday all, The Thrust bearing was fine, replaced it though. I have just finished re-installing the gearbox and new clutch, it all went together pretty well. I have an issue though, when i put the slave cylinder on, it automatically pushes hard on the fork, therefore pushing the thrust bearing hard up ...

Yep, the clutch was working and didn't appear to be slipping or anything...

The thrust bearing is fine

Apart from the damage, it all looks in pretty good nick, still plenty of meat on the disc etc.

I have a new clutch kit, the plate looks the same as the new one.

Below are some photos of my clutch that i pulled out of my '86 Landcruiser BJ74. The clutch has always been funny (activated at about 1 inch from the floor). I have replaced the master cylinder and the slave cylinder to no avail. So i pulled the gearbox (off for a rebuild) and found this: http ...

tanz-e wrote:

V8 Middy wrote:That's Matt at All Wheel Drive on Waverly Rd East Malvern. The phone number is right.

Don't make any decisions till you've been there.

have you had trouble with his work??

X2...... what's the deal?

sorry, 5 spd manual

Gets stuck in third when decelerating and slips out of 5th on the highway

Gday guys.

I am in need of a gearbox rebuild... for my landcruiser BJ74

Anyone know of any decent rebuilders in the south/east of Melbourne or in the mornington peninsula

thanks

done that, it's fine

Gday all,

I have these two oil leaks in the rear of my '86 BJ74...
Any help? Is it just a matter of replacing a pinion seal and gasket? or maybe an axle seal too?


thanks

Thanks. I pulled a vac line off the pump and straight away got around 25in/Hg. So i think it's fine Then i pulled off the vac line to the booster and heard the 'psst' of the vac and plugged my meter in. It SLOWLY rose to the same level as the pump. (or just under) I also found that there is a sensor ...

sorry, BJ74, 13BT engine

Tanks for that, the clutch feels the same as normal.
Ill start isolating the problem by removing vacuum components

Gday all, Another problem arising from my weekend away... The brakes are not working well. After continued use into the camping location, the brake light came on on the dash and the brake pedal went hard and the brakes barely worked. After putting up with it throughout the weekend, i figured it was ...

Yeah, after further investigation, the pulley is OK, ill see if i can get a replacement bearing. The pulley must be harder than the bracket it mounts upon, because it has dug out a chunk in the bracket!

ill get pic for ya soon

OK, turns out the bearings have completely smashed and the pulley was "hanging" in place.
TOYOTA says NO, so im trying to figure something out.

thanks mate, ill pull it off and check it out

Gday all, After my weekend away 4wd'ing, (in my '86 BJ74, 13BT) there was a strange 'whiney' noise coming from my engine. After washing all the dirt off, i found the tensioner pulley for the power steering had sort of buckled to one side an was on an angle. The belt is half worn away and i dont know ...

i cant help, but i'm looking for the same, for my bj74 landcruiser.....

Gday all, One of the problems with mt new '86 BJ74 13b-t is the clutch... It works OK, but doesnt activate until about 70% of the way to the floor, it has Massive freeplay before anything happens and then it all happens in about 2cm. Because of this (i think), it crunches into reverse sometimes, and ...