Outer Limits 4x4 Board

Adjust your idle up.

Just weave a loop into the end like you do on the hook side and use stick on sand paper on the drum. You can then roll the whole lot out and it will not spin norwill it ever run of.

Oils aint Oils. lol. Castrol is a good brand. I used Nulon diff oil a little while back and have been up north and back twice towing and all is great.

Cris

Yeah mate. GQ 4.2D then turboed it. Even the clutch pedal out of the GQ bolted up but had to cut and move the pedal over a little.

Cris

You have to cut out that piece of the cross member that the front tail shaft rubs on.

Cris

http://i52.photobucket.com/albums/g36/kymmymoo/Lukesrollcageandtray011.jpg
http://i52.photobucket.com/albums/g36/kymmymoo/Lukesrollcageandtray009.jpg
http://i52.photobucket.com/albums/g36/kymmymoo/Lukesrollcageandtray012.jpg

All photos the gear stick is in 5th gear and you can see the pto ...

killalux wired mine up and he got the tacho working but it only kicks in after 1200rpm which is no problem at all.

cris

Wizard x 2

Cris

Just a question to those 4by's with winches....when do you use your winch and in what situation do you use them?

Kind Regards.

When we get stuck and a mate cannot snatch strap us. We only use it when we cannot reverse out of a situation or when we cannot drive any further forward after having a ...

I do not have a body lift and there is no rubbing in the tunnel. If your local to brisbane you are welcome to come and have a look. I will take a couple of photos and email them to you.

Cris

I fitted one to my GU. I went from GU auto 4.5 petrol to GQ manuel 4.2 Diesel and I had no issues. Yes the GQ and GU box have different top hats and I have heard of people trying to do the swap with no luck. I can take a photo if that helps. ;-)


Cris

Who sells the replacement tubes. Maybe the old simex tubes are still available for them.

Cris

Looking good fellas. If I still have the truck I will be trying this out next year.

Cris

Relay

high beam (+) -> Switch -> Relay Pin 86
Relay Pin 85 (-) -> GND
Relay Pin 87 (+) -> Lights
Lights (-) -> GND
Battery (+) -> Relay Pin 30 must be fused

best to get a test light to test for high beam positive on the back of one of your headlight or under the dash depending where you take ...

Even better if you know any US flight attendants, most get up to 80% discount of air freight.

Cris

I am running a $310 10% more clamping pressure than standard clutch in my turbo GQ motor in my GU and have done over 20 000km,s to the cape and back towing with no problems at all. I guess time will tell.

Cris

A lift pump will make sure that everything else will be able to do its job properly. Do it.

Cris

We just did Cape York to the tip and back to Brisbane with new dobinson shocks and they performed absolutly awsome. The GU just stuck to the corragations and was a smooth ride. No need to throw good money away when a great ride can be had for way less.

Cris

No problem with Davies Craig last 4 years but there are better quility ones out there.

Cris

Laurie Sternbeck runs similar in his 1UZ. What motor you running.

cris

Rod & Russell 1st
Rod & Kevvy 2nd
Lawrie & Matt 3rd
Christian & Craig 4th
Lynda & Aaron 5th

Cris

In the Dump pipe. 900 It all comes down to what pistons the motors are running. I read to make the vehicles more efficient they have purposly run EGT hotter but they also redesigned the pistons to take the increase in temps.

Cris

860 C seems to be the Audi V8 optimised running tempreture :shock: I know the audi V8 and my TD 4.2 are tow different motors so I dont think I will test the boundaries. :D But I do feel safe hitting 650 although I do think adjusting the timing will lower the exhaust temps a little. Just cruising I ...

Have you had problem connecting your earth (-) to the chassis, then when the draw got too high it smoked some wires that were smaller grounds as it was trying to use them as well? No never had a problem. If that was the case every time you turn the starter key the earth draw for the starter would ...

If the Navara has the most output I would be grabbing it.

Cris

Hi Cris,

Connecting to the starter would simplify things greatly for me and would be the best scenario but almost everyone else I've asked told me it was a must to connect directly to the batteries? It'd be great if they were all wrong... Can you confirm? Any drawbacks with going to the starter ...

Cris

You can connect to the starter motor + for the positive and connect earth to the chasis.

Cris

Apart from legal crap what is stopping me striping down the front leafs on my hilux down to the main leaf only and replacing the shock with a coil over style shock.... Seam like a fairly simple way to to make the front nice and smooth with lots of travel. Am i missing something???

I dont see any ...

I am just curious if anybody has fitted a pyro to there factory Turbo vehicle with standard settings. If so what temps did you get.

Cris