Outer Limits 4x4 Board

I currently have an 89 sr5 4runner with a 22r. I am in the process of putting a 3rz in it.
I bolted up the 3rz Bellhousing and the input shaft seems to be too short.

I took some measurements and the 3rz belhousing is about 10mm longer.

Has anyone else had this?

Hey Guys

I cant find plug D can anyone help? A photo would be nice or just a general description.

I was looking on the trail gear website and they have whole dif centres with new 5.29 ring and pinion as well as a detroit locker for $999. I am considering getting one. They also had air lockers for an extra $370. Anyone else interested so we can save on frieght. http://www.trail-gear.com/assembled...

Hey everyone. Started my 3rz conversion today started sorting out the wirring.

Do I still need the emission control unit? I am leanning towards no but thought best to check.

Also what about the voltage regulator?

Thanks

Hey Guys bit of a grave dig but thought it should all go in the one thread. Just got a 3rz yippee. Cant wait to get started. Couple of things. When people mention loom what exactly does this include? is it all the wirring in the engine bay or just the wires that run to the ecu? Again with the wirrin...

because it hangs to low below the chasis rails. so if i am going to swap it i may as well get something that gives better clearance.

Thanks would it be posibble to see some photos. Also what is the capacity?

Hey guys i am about to begin my 3rz conversion in a 894runner. I know that i can use the v6 fuel tank as it has a electric fuel pump but i dont like how low they hang below the chasis rails. So just after some ideas of what other people have done. Would the tank out of an 80 series fit under the rea...

Hey mate. I just bought a 3rz as well and am just about to start this conversion.

I did a search on the forum and found plenty of good info.

Are you going to keep the g52 gearbox?

Thanks for the help guys. Has been resolved. Turns out it was the uni joints there was no play when i checked them first, I think they must have bound up. Woops.
All good now thanks again Outers.

I have a 89 4runner and want to rebuild my transfer case and gearbox. Just after any one who has done this to get an idea of good and bad kits out there and anything to look out for. It has a g52 gearbox and auto locking hubs, which i want to get rid of. Will the tranfer case from a manual locking h...

I wouldn't call it mild.
I will check the rear pinion tonight. and report back.

Also how do I check my enigine mounts are ok

Hey Guys I have an 89 4runner. When driving particulary at llower speeds around 40km/h the car vibrates. It is worst when deccelerating using engine braking. Have checked Uni joints and they are fine. Someone suggested maybe engine mounts. If so how do i check engine mounts. All help is greatly appr...