Outer Limits 4x4 Board

Thanks Man, will keep looking for someone who can do shims.

Anyone have any ideas? Ticking sound starts when warm 2RZ-E motor 200k. Ticks while driving, on free reving seems to tick on deceleration only, these tappets/lifters use shims and can't be adjusted but noone seems to be able to do shims. Have been to a few places and the diagnosis has varied from ...

Typically, the interior light works off a switched negative, not a switched positive. So the interior light, typically, the bulb has a constant positive on one side. You put the switch to "on" and it just earths out the other side to the body, switching it to "door" changes it so it hooks to the ...

Rear shaft will give you vibes but not death wobbles. Check the tie rod ends for play. Inadequate swivel hub bearing preload would be my second bet. Fair call. Yep, I'd be looking at what Ray185 has said. Did you replace em yourself? When? Did you miss something? Kingpin bearings? Did you shim it ...

A smarter man than I would have asked for more info before offering advice. A smarter man again would have offered this info without waiting to be asked. :finger: I assume you've had the wheels balanced and swapped front to rear to eliminate tyres/wheels from the list of possible causes? When do ...

Thanks guys

Bearings and bushes all new, not shackel pins either, with drive shaft do you mean front or rear? Front is not turning in 2wd and still happening, will try change rear on one end by 90 degrees and see if that helps.

84 Hilux getting Death wobbles but where to look

Steering Box Recod
Wheel alighnment done
steering damper changed

Have heard of preload but was told not needed on Lux?

Summary of the australian standard for bull bars

http://www.racv.com.au/wps/wcm/connect/ ... +bull+bars" onclick="window.open(this.href);return false;

4wd built after 2007 - Regulations 2004 states that it is a requirement that vehicles built to comply with ADR 69 - Full Frontal Impact Occupant Protection continue to do so.

1. Good set of Muddies
2. Good Suspension
3. Lockers

x2 for OUTCAST OFFROAD, Burleigh QLD Greg-0424 705 300 http://www.outcastoffroad.com.au" onclick="window.open(this.href);return false; Great service, did some cusom bash plates, under body protection and some other bits. If you need something custom to make your truck stand out give him a shout.

They don't release easily under load as the gears are locked, relaese some throttle and you may find it will release. Quick test is to try engage while stopped and then just roll forward after unlocking and it should pop out otherwise time to pull apart.

Bike ones need a groove cut into them or they do not air down properly, once done with good cleanup to remove any metal bits and they will work.

Some info that may be helpfull here http://www.v6conversions.com.au/hilux4runner.htm" onclick="window.open(this.href);return false;

A simple diode will fix this, allows the 12v DC to travel only one way and blocks the other way. It will need to be installed "in line" by cutting the wire to the light and soldering or crimping it in.