Outer Limits 4x4 Board

Fitting an extra water trap in common rail injection systems is not as straight forward as some people seem to think. If your system has a pusher pump in the tank all is good, but if the system has a sucker pump combined with the high pressure pump it can be over loaded and fail,big $'s. Not ...

A question for the diesel experts out there. Is it acceptable to put metho in a plastic diesel fuel tank (common rail injection) to disperse a very small volume of water?

It would probably be a good idea to check the the computor for fault codes could save a lot of time and money.

I think you need to check the alignment of the alternator pulley first, if you fix that it will save you a lot of stuffing around.
Lots of vehicles run high output alternators and std vee belts.

It doesn't matter it is connected to a heating element when on 12v. will draw about 8amps or more though, so don't leave it connected for too long with the engine not running.

usually a little grease on the thread of the nipple solves the problem

Pauly
Are you still looking for the wiring info ? If you are I have done this conversion and have a few wiring diagrams so may be of some help.
Watty

Is it possible to interchange the dissys as the two wire dissy has a magnetic pulse generator. The three wire dissy appears to have a hall effect switch. I'm doing a belano distributor engine convertion to sierra, bought a vitara cam dissy and right angle drive housing and discovered the difference ...

I would suspect that you have blowen the head gasket or cracked the head

Check the retaining screws that hold the rocker shafts are still in place. They can fall out and allow oil to squirt direct into breather on the rocker cover and if they get under the cam, a lobe is capable of pushing the screw through the head into the water jacket.