Outer Limits 4x4 Board

With the electrical plug connections, the yellow one from the alternator( the thicker one) goes to the ignition feed, this is the voltage sense. Check with a multi meter that it is the same voltage as the battery, because if it is lower, then the alternator will overcharge. The other one is for the ...

has there been any fuel map changes to compensate for the extra capacity and fuel needed? If not, then did it ever idle properly. As said before, disconnect the snorkel and then the filter and see what happens.

if you run a map sensor, you need to have a variable throttle position sensor also, or it would not work. A few things make a standard computer not work with boost.

Its not a good start if you are asking what sort of air box is used. Do a lot of research on other forums as what is needed to be done to a vit efi is similar on a lot of other 4 cylinder engines. Its certantly not as simple as bolt it on and away you go. Some factory computers wont work with boost ...

Is the Falcon 110A alternator a general upgrade for the g16b? if not, then what is a usual option?

it would make it skip even worse as it would wind up and then completely release stress, then load up again. It would only last a few weeks, if that doing it the way you are wanting. It will just tear the gear apart. I have seen people do it this way and not last a week. Only way to weld is to compl...

Do the parker's at the front work? Does it have a trailer plug?

This is a general rule for any vehicle with H4 headlight bulbs. Connect pin 30 to the battery feed, Pin 87 to Both the spotlights. Pin 87a to nothing. Pin 86 to one of the vertical pin wires on one light, Pin 85 to the other vertical pin of the bulb and through the switch on the dash. Using either s...

you need to be a little bit more specific or put up a picture or something. Most of the time a dual battery solenoid has a jump start over ride, as in it connects the contacts when the switch is turned on.

In term of a single battery setup, they are not designed as a start and charge battery, they are designed to have a current output for a fair while, and get a full charge again. that is when they last the longest. It would still last a fair while, but for the size it would not have the CCA as a regu...

yeah it is. It would be cheaper the more there are. They are $60 for the kits themselves, and take about 1.5 hours to make properley. Im a qualified auto electrician so i know how to do thing properly.

There is a kit that i can make that is a digital speedo, and it also doubles as a speed alert. I have one, it is very accurate and only takes one push of a button to calibrate. The kits are not assembled, as in everything needs to be soldiered in place. If i have a few people wanting them, i could m...

I used to run some 30" chunky muds, 9.5 wide with a 16valve 1.6efi. I used to get 9km's per litre. Now with standard sized tires im getting nearly 12km's per litre. These figures are not exact, but pretty close and i did no other mods. And it has heaps more accelleration and i dont have to put ...

I got done for a defect having 30 by 9.5's muds on some sunnies. They stuck outside the guards about 20mm, so that was not good to start with. I only have a 2" spring lift, no other standout mods. It was clean at the time and i was driving well under the speed limit on a sunday afternoon. It di...

you could try and find some sort of truck wreckers cause all larger trucks have air tanks for the brakes and suspension, heaps of sizes available.

u should also mention that u r putting a swift gti motor in ur zook, cause of the clutches, etc.

from my understanding the gti angle drive kit fitted g13b twin cam engines from the 1989 - 1996 swifts. and urs is an 1989, so i think it fits, unless its 1990 - 1996.

pulsr@iprimus.com.au

that is his email address, it says so on the page. the only other way if the mazda cap dont work is to cut ur fire wall and prob have no heater, or move it. or else u need to get another motor. what year is the gti motor out of? also how many k's?

hey mate, check out this site, it tells u nearly everything that u need to know, also if u dont want to buy a suzi sport angle drive kit and cant find a short dizzy cap, u can also cut a box section in the firewall and then plate it up as a box. http://home.iprimus.com.au/pulsr/g13b/ are u going n/a...

as far as i know, the law states that a vehicles width from the centre of the rim on each side of the car can not exceed 50mm wider than stock, there fore hilux diffs are not allowed cause they are like 100mm wider at least, that is the width of the diff, also not allowed more than 50mm of height in...

if u want a cheap alternative for the rear shocks, just get some rear early model hilux shocks for about $20 a pair and some recent model VS commadore wagon Rear shocks, Eye to Pin. only about $30 to 40 a pair. cheers.

hey, try putting vs commodore wagon rear shocks in the front of ur zook, worked sweet on me mates sierra with 2inch lift and ruf, long shackles, etc. good travel, only like $30 for a pair at the wreckers.

hey, just run a positive feed into in 30 and 86, 30 is the switch input and 86 is the coil positive feed. then just run a wire from 87, not 87a to ur light and also run the output from the coil, which is 85 to ur light feed, to keep it negative switched. if u want it positive switched, put the feed ...

prob cause everything is already slightly enlarged, eg bore and yet the new pistons and rings still stay the factory size. also the main bearing journal on the crankshaft would be slightly worn, only ever so slightly. also depends on how the motor is worn in, if it is booted around the first corner ...

the inline fuse is actually placed close to the battery to prevent an explosion. if the vehicle is in a crash (very bad) and the + power cable shorts with the chassis (usually only with high powered amps) a large number of amps will pass through the cable and cause a direct short to the battery, if ...

uni mogs are sweet machines, we had one in at work from the army, stock as, and could do all things a zook could, and even more. i dont think he is goin to keep it completly stock, im sure he is goin to do some mods, cause u dont need to do anything to a uni mog to make them really really good, caus...

hey, just wondering if there are any major problems with putting dana 44's under a zook, still using leaf. can the drive shaft adapt, if not, what transfer case can be used becides a ford f series or a bronco.