Outer Limits 4x4 Board

ok. uni's seem alright no play, tight as.
Still have about 1/4 turn and get a clunk noise from diff when rotating quickly.
ferrit the diff was replaced about 12 months ago after it letgo. But will check it now.
Cheers, Andrew

I can rotate my rear tail shaft about 1/4 turn. Is this normal? It clunks when accelarating away from a stationary position. It has no forward/backwoard movement only rotational. Is it the diff or the transfer that may have the problem? 1990 petrol diffs to sierra transfer. Any ideas would be great ...

so what ru saying??? u are using a vit motor and box and transfer?? what had to have a custom jack shaft??? from where to where I have an X-90 (Vit) motor and 5spd box mounted on the original engine mounts. This is mated to the standard Sierra transfer in its orignal position. The jack shaft runs ...

(Could be burned here so flame suit is on) It can be done without a body lift! I'm not sure about the suspension lift in order to clear the sump as i run Lux diffs. It will fit in the tunnel with a small amount of massage. But you need to fit a custom "jack shaft" (box-transfer). Aslo once in place ...

My front hubs seemed screwed (avm) one locked in 2wd and the other 4wd. Once i have them apart and back together......Is there a way of confroming i am getting drive to the front wheels? (Short removing rear driveshaft). Last time i was out i was told that on a rock step i was getting no drive out ...

Hi Guys,
I just bought a second hand roof console for a 100 series crusier. Does anyone know where i could get a wiring diagram from?

Cheers,
Andrew

I've just pulled the rear main out of my 1.3 Sierra. It was completely destroyed and haemorrhaged big time. When replacing it with a new one it is supposed to sit flush with the back of the block or pressed in completely?

Thanks Heaps
Andrew

In the process of changing an axel seal...
After removing the manual locking hub i am stuck trying to remove the nut and washer in the end of the axel.
Each time i attempt to undo it the axle spins hence having no affect in undoing it.
How can i stop this?

Cheers,
Andrew

Very tidy work boys. Saw it in the flesh awesome looking rig.
Well done sean, guru and sam

sweet looking rig...........nice job boys