Outer Limits 4x4 Board

For those interested, the part is $17 from nissan, no current gasket and o ring rebuild kits in aust.....they are $200 +

thanks mate!

is it avail at repco?

Hi Guys,
After spending the afternoon smiling with pride polishing my patrol, i changed the oil, and fuel has started dripping from the bottom of my fuel pump, it seems to be coming from the diamond shaped plate pictured, can someone clarify and suggest repair?

Thanks heaps guys,
(just about to ...

Im back!, when i first joined i had a fully modded '89 GQ Diesel turbo and loved it, thanks to QLD regs i had to get rid of it, since then i've had a 2001 jeep cherokee, a 1997 suzuki sierra and a 4.2 TB42 GQ, and i've just picked up my new 1989 Nissan Patrol GQ TD42 with a 2 in lift, turbo and ...

thanks guys, your legends, ill give it a go in the morning, thankyou so much
warren

Hello all!,,,,help!
i removed the dizzy to change the o ring cause it was leaking, tried desperately not to move anything but i think i have, it wont start, i gives off a few pops here and there, i dont have a timing light, is there any way to get it going again?
please please please
cheers
warren

Hello there all,
How hard is it to change the rear main seal in a coily zook?, are there any special tools required?, could someone provide a step by step for me(ive seen one around....somewhere!), im mecanically minded but ive heard there a b&^ch to fit, ill pick up the seal tomorrow and do it over ...

Yeah i think your right, the caliper seems a bit on the sticky side, ill rip it off on the weekend, oh and by the way i put the sway bar back on and it seems to have stopped it a bit, this give any of you any more clues?

Bump, ok new update, the right hand side front disk and rim and everything around it was purple hot when i got home today, not through excessive braking though, is that bearings?

OK thanks for all the 7 suggestions ha ha, ill get in there and have a good push and pull on bits and pieces, see what i can find.......
thanks heaps again fellas

warren
any more suggestions..keep em comin!

also check the seals around the swivel hubs or simply replace them

Your kidding!, ill have a look but....what those tiny little rubber seals soak up vibrations?
well ive seen stranger things happen, but that was on the GQ!!!!

Hey fellas,
Here's the story, driving at about 60k's on normal suburban streets, hit a small bump in the road, and the wobble from the bump gets worse until im using all the strength in the world to hold the wheel, if i look at the tyres whilst it is happening they are wobbling left to right, the ...

Hey fellas,
About 3 months ago i was stopped at the lights and went to take off, i heard a big clang from the drive line, it progressively got worst and worst to the point it was undrivable, i honed it down to the transfer box and ripped it out, pulled it apart and discovered the chain had about 2 ...

thanks christover,
im gunna try the fuel tank thing, because i noticed on the way home i filled up and the vacume in the tank was amazing thanks for the help
warren

heres what has happened so far for a bit of history....
http://www.outerlimits4x4.com/PHP_Modules/phpBB2/viewtopic.php?t=85207
now what is still happening is, i will be driving along all good and it will lose all power, it seems to happen more on gentle uphills, to rectify this i have to find the ...

Ok fellas,
Alternator all fixed, here's what it was, pulled alternator out and one brush was fine but the other was stuck all the way in, charging fine now.
thanks heaps for all the help. now onto my other problem...........

ok, tested again
battery connected
between pos post on alt and casing of alt, no continuity
between pos batt term and pos post on alt, continuity
between neg batt tern and casing, continuity
pos and neg batt terms off
between pos post on alt and casing of alt, no continuity
between pos batt lead and ...

ok, tested again
battery connected
between pos post on alt and casing of alt, no continuity
between pos batt term and pos post on alt, continuity
between neg batt tern and casing, continuity
pos and neg batt terms off
between pos post on alt and casing of alt, no continuity
between pos batt lead and ...

but the alternator is generating power, 13.5v at 2500rpm?? what tha???
thanks for the reply, anyone got any ideas
cheers
warren

i think it is charging, when i put the tester on the positive conection on the alt, and negative on casing( both disconected from batt) it reads 13.5v at 2500rpm at the alternator, but the charge is not getting to the battery, what tha????
hope this helps
warren

unfortunatly didnt work fellas, heres the full story to date PLEASE HELP :oops:
i took my 97 coily zook for a swim on the weekend in the mud, on the way home the charge light came on, it disappeared after a while, then it came back on, then off and then on permanantly, drove 150ks home, and i was ...

ok fellas,
i took my 97 coily zook for a swim on the weekend in the mud, on the way home the charge light came on, it disappeared after a while, then it came back on, then off and then on permanantly, drove 150ks home, and i was having problems with keeping it running all the way home, it would all ...

thanks heaps fellas, ill give that a go tomorrow after work
thanks again
warren

Hey folks,
went to cruiser park on the weekend, had a ball in the mud BUT!, got myself all muddy and now the alternator light is on and the battery is not charging at all, is this common?, ive cleaned it all up and still have the same prob, also it was loosing all power and stopping completly on the ...

prolly will but only cause of the increased angle on the axle at a higher articulation, judging by what sort of off road work i would imagine you get up to...i doubt you will crack a cv

didnt want to start a new thread so, are the leaf and coily diffs the same, will a lockright fit? or is it a different model?
cheers

hey can someone give me some advice on how to takle replacing the rear main seal, i know the tranny comes out and all that but do i require any special tools or anything and any tips to make em last longer!
cheers heaps

hey to all those blokes with coils and 2 in lift, what front struts did you use and how are they, and where did you get them from???

wicked, i have a 97 coily, most of the stuff will be the same ey, like replacing the rear seal and stuff?

thanks, whats the best manual to get for a zook, the gregorys one doesnt exist is there anything else?
cheers