Outer Limits 4x4 Board

HJ/fj75 and HJ/FJ60 gearboxes are the same from 1984 to 1990. The HZJ75 then has the H55F but it had a fine spline front shaft where the 1984 to 1990 box had a coarse spline front shaft. cheers

I am pretty sure mine did the same however it was about 4 years ago. Picture may help if you zoom in on it. Regards

2H flywheel after machining, cheers

Cheers, It is my understanding that if the fly wheel is not machined that the warranty is void if you need to claim.
It may pay to check this out, anyway.

Yes, the 88 HJ75 should have 2 resistors in the manifold and 6 volt glow plugs.

hulsty wrote:In a 80 series what manual box is behind the 3F ? Is it a constant 4wd H150 ?

No, Part time transfer with locking hubs

Thanks Jonezy, LOL, Have had a couple of similar handbrakes myself, Cool.
She only picked it up today so I will find out a bit more about it tomorrow.
Regards gazza

Cheers, LOL, Is that your handbrake on the ground in front of the truck?
A shiela from work just bought a 2003 4 cylinder petrol ute and wants wide rims. As it is a 2wd does she still need to go to 4wd sunnies etc or are GXL rimes wider than the standard rim, Thanks.

cheers, this may help.

Repco in Townsville can fit the oil squirter's. They told me they turn the block upside down and machine the location and then drill and tap the block at the correct angle. If you rebuild use steel sintered pistons . X2 on what Flyology said on the alternator. I got the same and from same people ...

RAY185 wrote:If it's anything like the 2f, it bolts to drivers side engine mount bracket.

X2 just under the power steering pump

i did do a how to on VY commo seats in my 75 in my thread but no one seemed to care lol Cheers Mate, I don't think that is the case, thanks for the effort. I have a VP Senator and it has great seats [diff to ordinary seats] and I sat one in the drivers position and it is then way too close to the ...

Those Honda seats look great, well done. I think that is the way I will go.
Anything has to be an improvement over the Toyota a$$ busters, LOL.
Cheers

Cant say specifically with the 3F but the 2H clutch plate will only go in the correct way otherwise the pressure plate bolts will not reach the fly wheel.

My HJ75 got so bad I bought a second hand wiper motor from Private Parts 4x4 in Sydney and swapped out the motors. It cured the problem but I have not pulled the wiper motor apart yet to see what was causing the problem. My wipers struggled like yours until they were obviously going to stop or burn ...

Come on mate think about 37 boggers legal in QLD i don't think they are legal anywhere. Im not worried about legal. I just dont wanna have these tyres here that have bugger all tread. And i don't wanna sell them. Rather regroove them then run them into the ground. May aswell get as much as you can ...

It is my understanding that unless the tyre is marked by the manufacturer as suitable for re grooving that it is illegal to do so in Queensland. Are your tyres marked suitable, otherwise un roadworthy , defect, no insurance. If you only use is off road on private property , maybe you owe yourself or ...

thanks for that boys. bigbrowndog do you have a number or sumthing for a.e.d thanks.......... nathan Cheers Mate, I bought mine here in Townsville but the alternator was sent up from Melbourne as they did not have one in stock, usually they carry one. Check yellow pages your area as on my receipt ...

The diodes often give up in these alternators but check the brushes.
I bought 13/1/10 a new alternator including vacuum pump from A.E.D for $350.00, 12v, 80amp, int reg 2H/12HT part no 098-13-840. Regards.

Thanks Pete, Mate I am not familiar with the short and mid wheel base cruisers. I have always had ute's and one wagon + a RR wagon. Just went by what my mate said but thanks again for your help.

He was grateful as he needs his truck for work, so thanks again everyone.

What model cruiser?
Yes,
Checked all the fuses with a test light. Nothing blown.
Looking at a wiring diag, I know there is a tail light relay, I just cant find it!

It is an '84 FJ 75 short wheel base FRP model.

Thanks Simon much appreciated,will pass this on to him.

Not sure about the relay mate but just letting you know the swb is the fj70 and the mwb is the fj73 and the ute and troopys are fj75's Yes you are right for sure I should have picked that up myself being a short wheel base with FRP top. I have a HJ75 but it is ages since I have been in the dash and ...

Cheers, A mate has no tail lights on his FJ75SWB but has brake lights. He says he has double checked all his fuses and they are OK. I thought the relay was near the aircon vent on left side of dash near the door but it seems there are two other relays there. Can you tell us where the tail light ...

thanks all for the info, i am waiting for a response from the mitsubishi website before i can post. until then, if anyone else has some info, i currently have a rb30 patrol and tow a small boat which takes its toll on hills etc. so am looking for a bit more power for towing and in general. am ...

The 1990 [Poverty Pack] had the 3F motor,part time 4wd, no tacho, vinyl floor mats and seats, and barn doors .

I just bought a new alternator 12V, 80A, N [ internally regulator] and the accompanying paper work says Voltage regulator set point is 14.65 volts and hot set point is 14.66 volts. The early H,2H were external regulators and the later 2H was internal, shows on page CH10, 2H 12HT engine workshop ...

Cheers, Can anyone tell me where I might be able to pick up an Internal regulator for the 2H alternator. Ingrams,A.E.D. Distributors and Cooldrive Townsville cannot get me one. They say they are no longer available and Dowkers Electrical here confirmed this. The alternator appears good apart from ...