Notice: We request that you don't just set up a new account at this time if you are a previous user. If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Have you checked for power at the motor. Not had bother with mine but they must be controlled by a relay somewhere. Put a meter or test bulb on the connection and earth to check for power.
lexi wrote:Have you checked for power at the motor. Not had bother with mine but they must be controlled by a relay somewhere. Put a meter or test bulb on the connection and earth to check for power.
Alex
Nah motor is fine, no problems there.
Its with the knob that goes into the door skin, the other end must be rounded off and not catching on something.
So yeah the motor is 100% working, the problem is within the door skin, an area I havent got access to.
More then likely it will be the plastic piece of shit cog that goes between the motor adn the winder cog on the window frame. Both mine have shagged out and its just a matter of getting them from nissan or elsewhere and putting them in
I have fixed three 3 of mine. The spindle that drives the sector gear on the window regulator breaks because it is die cast rubbish. I have a two step method. If you clean as best as possible and can get some high shear strength loctite into the gear you can re glue it. failing that they can be welded with 2 big washers. Also the rubber shock mount on the worm driven gear shears as well but again you can remove the rubber and rebuild using epoxy
Doggy wrote:More then likely it will be the plastic piece of shit cog that goes between the motor adn the winder cog on the window frame. Both mine have shagged out and its just a matter of getting them from nissan or elsewhere and putting them in
Nah that piece is still in perfect condition, the fault is definately something inside the door skin. I just havent been game enough to remove the whole thing to see what is actually the problem.
both passenger side windows go down fine, but only come back up a few inches and then sort of "die" (when passenger switches are used) but they work up and down perfectly when operated from the drivers door switch. Does anyone know what could be causing this?
both passenger side windows go down fine, but only come back up a few inches and then sort of "die" (when passenger switches are used) but they work up and down perfectly when operated from the drivers door switch. Does anyone know what could be causing this?
Bad contacts in the switch. Mine do it from time to time too. Pain in the arse.
You've got to strip the switches down being careful not to lose fiddly little pieces and give the contacts a bit of a clean with a file, etc. Should keep you going for a while till they corrode up again.
[color=violet]G[/color][color=white]O[/color][color=yellow] S[/color][color=blue]T[/color][color=yellow]O[/color][color=white]R[/color][color=violet]M[/color]
Premiers 1999, 2007, 2009
Spoon 2010
