airbox mounting

Post by **chrissuzuki** » Sun Mar 25, 2007 11:43 am

Hi guys,

Currently doing 1.6 16 valve efi conversion on my sierra. Just after some pics of how others have mounted there airbox or other vehicle airboxs which are a better fit?

Any help would be great. Thank you.

Post by **nicbeer** » Sun Mar 25, 2007 12:17 pm

Hey,

Take a gander at this thread;

http://www.outerlimits4x4.com/viewtopic.php?t=100149

I am using the orig vit airbox in my sierra conversion and hope to hookup a 3" snorkel as well.

I can get any more pics if needed.

Nic

Post by **hyzook** » Sun Mar 25, 2007 7:42 pm

I run the vit airbox as i believe the efi was set up with it and i think it runs better since i changed it (origonaly had the sierra box in there) I also run a snorkle off it.
I will try post some pics tomorrow.

Post by **chrissuzuki** » Mon Mar 26, 2007 1:13 pm

Cool thanks nicbeer, thats a neat engine bay you have there. That looks like the setup i was thinking of.

Thanks hyzook any pics would be great.

Chris.

Post by **hyzook** » Mon Mar 26, 2007 1:47 pm

OK here are some pics of the snorkle and box.
I plugged the origonal intake hole with rubber and urathane, then using exhaust tube I cut a series of slots at one end and bent a lip right round it and slipped it through a new hole in the airbox and urathened and rivetted it. The snorkle which is bolted down to a bracket on the inner gaurd is then joined to the pipe with a rubber hose and clamps.

IMG]http://i164.photobucket.com/albums/u30/ ... 0_0589.jpg[/IMG]

Post by **nicbeer** » Mon Mar 26, 2007 3:46 pm

Post by **chrissuzuki** » Wed Mar 28, 2007 7:31 pm

Good job hyzook that looks very tidy. Well got some ideas now thanks guys.

Chris.

Outer Limits 4x4 Board

airbox mounting

airbox mounting

Who is online