Hi all, your my last hope with this, it has me stumped...
I have fitted a HID conversion kit to my isuzu trooper, no problem and the light is much improved.
However, the spotlight feed to the relay that controls the spotlights from the headlight, no longer works for an unknown reason. The old feed was taken about 3 inches back from the drivers side headlight and has never been a problem - until HID that is.
When i unplug the HID wiring harness and fit a standard halogen bulb, the spotlights relay works fine.
Have any of you guys any advice on where to take a spotlight feed on an HID headlamps?
Any help gratefully received!
regards,
Henry
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
HID and spotlights
Moderator: -Scott-
I'll guess your spotlight relay coil is being earthed through your low beam filament.
When low beam is on, both sides of the coil are high, so the relay switches off. When you switch to high beam, the low beam line is pulled low through the filament and the coil switches on.
I'll also guess that your HID kit doesn't do the same. When you switch to high beam, there's nothing (i.e. no globe filament) to provide a path to earth for your relay coil, so no spotties.
IF I'm right, you need your relay coil across the two outside wires of the H4 globe socket. Do not connect anything to the middle wire of the socket.
Good luck,
Scott
When low beam is on, both sides of the coil are high, so the relay switches off. When you switch to high beam, the low beam line is pulled low through the filament and the coil switches on.
I'll also guess that your HID kit doesn't do the same. When you switch to high beam, there's nothing (i.e. no globe filament) to provide a path to earth for your relay coil, so no spotties.
IF I'm right, you need your relay coil across the two outside wires of the H4 globe socket. Do not connect anything to the middle wire of the socket.
Good luck,
Scott
Many thanks for your advice Scott.
Your exactly right the HID kit doesnt switch to another filament - instead it simply moves a cover inside the bulb to direct the beam of light to a hi position from lo, or vice versa.
I tried to take a feed from the now unused passenger side headlight plug, however when connected the feed seem to short out or earth the HID loom - when I flicked from hi beam to low the beams stayed on hi and the dash light stayed on.
However this was not across the two outside wires on the globe socket, just the one and then to earth. I will give that a try now!
Thanks again Scott.
Your exactly right the HID kit doesnt switch to another filament - instead it simply moves a cover inside the bulb to direct the beam of light to a hi position from lo, or vice versa.
I tried to take a feed from the now unused passenger side headlight plug, however when connected the feed seem to short out or earth the HID loom - when I flicked from hi beam to low the beams stayed on hi and the dash light stayed on.
However this was not across the two outside wires on the globe socket, just the one and then to earth. I will give that a try now!
Thanks again Scott.
Who is online
Users browsing this forum: No registered users and 0 guests