Can someone tell me how I'd adjust them
Joe
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
How to adjust Koni shocks?
Moderators: toaddog, TWISTY, V8Patrol, Moderators
How to adjust Koni shocks?
I've got a set of Koni's that came off my previous wagon & I want to adjust them for the GU ute I recently picked up.
Can someone tell me how I'd adjust them
Joe
Can someone tell me how I'd adjust them
Joe
More poke = More smoke!!!
from memory it is turning the upper part of the shock clockwise and anti clockwise to set it from soft to hard.
If i remember on my own turning the top half of the shock anti clockwise lookin down at the shock stiffened them up (i think.. or is it the other way around?)
TOM
If i remember on my own turning the top half of the shock anti clockwise lookin down at the shock stiffened them up (i think.. or is it the other way around?)
TOM
custom bar work, 4x4 parts, trailers, anything out of steel/alloy :D
Compress them all the way. Once it's compressed turn and push it together. You will feel it slip into place on the adjuster. Turned as required. You will be able to tell how much harder/softer you are making it by simply extending and compressing the shock. Clockwise makes it harder, anti clockwise is softer.
Good choice of shock
Good choice of shock
[quote="Uhhohh"]As far as an indecent proposal goes, I'd accept nothing less than $100,000 to tolerate buggery. Any less and it's just not worth the psychological trauma. [/quote]
On my Konis (15yo orange (non gas) for a road car) you need to remove a rubber "bumper" from inside the 'hollow" section before you can compress far enough to adjust the valving. There's a hole near the top - push a wire through, and push the rubber out of the tube. It's split, and pulls off the shaft.
On mine, they only adjust travel in one direction (think it's compression - could be wrong.) So it always has the same resistance in one direction, but the other direction moves from easy to move to almost rock hard.
Good luck,
Scott
On mine, they only adjust travel in one direction (think it's compression - could be wrong.) So it always has the same resistance in one direction, but the other direction moves from easy to move to almost rock hard.
Good luck,
Scott
Spot on that man. You need to hold a little down pressure on the shaft to ensure it does not slip out of the adjuster when turning clockwise for harder or anti-clockwise for softer.Ruffy wrote:Compress them all the way. Once it's compressed turn and push it together. You will feel it slip into place on the adjuster. Turned as required. You will be able to tell how much harder/softer you are making it by simply extending and compressing the shock. Clockwise makes it harder, anti clockwise is softer.
Good choice of shock
Cheers
Stock 'Cruiser X 2
www.dnaoffroad.com.au
www.dnaoffroad.com.au
Who is online
Users browsing this forum: No registered users and 0 guests