I just purchased a 2006 Jimny JLX to replace my Vitara that was written off, and wish to remove the rear seats to increase the room in the rear of the vehicle.
I have had a look at the seat, and it was not apparent how it can be removed. I would assume that you have to remove the bottom of the seat, before un-bolting the backs.
Has anyone removed the rear seats of their Jimny?
Thanks,
Sally.
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Removal of Jimny Rear Seats
The lower parts are easy, pull them forward so they sit up against the back of the front seats and undo the bolts on the floor on either side.
The tops:
Put them right forward and you'll see bolts on the floor between them, they may have a plastic cover on them depending on your model. Undo these.
On the sides, (push the fabric back) you'll see floor bolts on brackets, and two L shaped mounts, undo these. I can't fully remember the rest, but if you have a look, you should be able to work it out. They basically slide out towards the middle (eachs other) off two protruding bolts into the side of your quarter panel trim..
Hope this helps.... oh, once the seats are out, make sure you put the bolts back into the floor holes where they originally were... otherwise you... ummm... will fill up with water
The tops:
Put them right forward and you'll see bolts on the floor between them, they may have a plastic cover on them depending on your model. Undo these.
On the sides, (push the fabric back) you'll see floor bolts on brackets, and two L shaped mounts, undo these. I can't fully remember the rest, but if you have a look, you should be able to work it out. They basically slide out towards the middle (eachs other) off two protruding bolts into the side of your quarter panel trim..
Hope this helps.... oh, once the seats are out, make sure you put the bolts back into the floor holes where they originally were... otherwise you... ummm... will fill up with water

DRS smells like a cat-food milkshake... and wet socks... and gorgonzola cheese... all whizzed up in a blender
Who is online
Users browsing this forum: No registered users and 4 guests