Well, last night the power steering pump started to whine. Checked the fluid level and it was down considerably. Checked the box and it appears that the lower seals are gone. Topped everything up with the Lucas goo and it it has quietened down a bit.
Question: Does the whine indicate that the pump is on the way out or is that just cavitation?
Can I get away with just replacing the seals in the box? I seem to remember that it is not that hard??
Can the pump be rebuilt?
Thanks John
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Power steering whine??
Moderator: Micka
Have a look at http://www.rangie.com/articles_topic.ph ... &subCat=86
there's plenty of info on seal replacement out there.
DL
there's plenty of info on seal replacement out there.
DL
not all the time as i have just had this problem with mine the seals in the box went i replaced the seals quite a simple job and the wine is still there even after filling with new fluid and bleeding it.cloughy wrote:The whine simply means low fluid
I am lookin at rebuilding the pump now.
I got the parts from a place cloughy recomended (top job to by the way) they are very helpful and friendly and had the parts i couldnt find anywhere else at a reasonable price they are 4wheel drives and are located at 304 Middleborough road Blackburn south in Vic the number is 03 98900509.
seal kit for 3bolt box is $44
" " 4bolt box is $93.50
power steer pump seal kit $38.50
gasket kit $33
plus gst yes i bought there catalouge
have grinder will fit
www.4Bfabrications.com.au
www.4Bfabrications.com.au
Thanks guys,
Picked up a seal kit today from FWD at Yerongpilly up here in Brisbane for $43 (wholesale - full kit, they didn't have the minor one for the output shaft in stock but I figure I will eventually use it and the price was good.)
Shall have a crack on my next days off and see how we go. Until then I shall keep pouring the Lucas goo in.
John
Picked up a seal kit today from FWD at Yerongpilly up here in Brisbane for $43 (wholesale - full kit, they didn't have the minor one for the output shaft in stock but I figure I will eventually use it and the price was good.)
Shall have a crack on my next days off and see how we go. Until then I shall keep pouring the Lucas goo in.
John
closet,
Have a look at all on this site as well.
http://www.rangerovers.net/repairdetail ... ngbox.html
I would not be trying to get the pitman off with a hammer as someone suggests. Will do damage to internals.
cheers, DL
Have a look at all on this site as well.
http://www.rangerovers.net/repairdetail ... ngbox.html
I would not be trying to get the pitman off with a hammer as someone suggests. Will do damage to internals.
cheers, DL
Who is online
Users browsing this forum: No registered users and 26 guests