Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

80 series help please

Tech Talk for Cruiser owners.

Moderators: toaddog, Elmo, DUDELUX

Forum rules
Post Reply
Posts: 8
Joined: Sat Jan 28, 2006 7:08 pm
Location: Bilambil Hights

80 series help please

Post by spenolie »

hi i have a 93 80 series with a 1fzfe it will not rev over 2100 rpms does any one have any ideas it drives fine until i hit 2100 rpms then the motor cuts out it doese not stall it just cuts out :?
Top
Posts: 72
Joined: Thu Jan 04, 2007 6:55 pm
Location: Melbourne, VIC

Post by DGS4WD »

Yep, 99.9% sure it will be your TPS (throttle Positioing Sensor). You need to seal it up with a tube a silicon. Did you just give your engine a wash? Is your dual Fuel?
I had this exact problem when I first got my 93 80Series. I would splash through some water and it suddenly wouldn't rev past 2100rpm, drop to idle, nearly stall and then kick back up to 2100rpm again. The next day it would be fine as it would have dryed out buy then. I found that it only happened while running on petrol and NOT LPG so that ruled out a few things.
Good luck.
T.L. 93 80 4.5 GXL Man
Gigglepin winch, beadlocked 37x12.5-17 sticky treps, flip arm, high steer, 6" dobinsons, 33" boss's, longfields, 4.56 diffs, 25% low range, lockers
Team: Cause For Concern
Top
Posts: 398
Joined: Mon Jun 21, 2004 7:57 pm
Location: Berwick, Vic

Post by g35me »

The butterfly in your air intake may be wedged closed.
Twin Turbo V8 80 Series Ute with Extra Bits
Top
Posts: 8
Joined: Sat Jan 28, 2006 7:08 pm
Location: Bilambil Hights

Post by spenolie »

I DID JUST WASH MY ENGINE ITS BEEN TWO DAYS AND STILL DOING IT SO THE TPS IS PROBABLY BUGGERED I DID GIVE IT A GOOD BLAST WITH THE WATER
Top
Posts: 8
Joined: Sat Jan 28, 2006 7:08 pm
Location: Bilambil Hights

Post by spenolie »

I ALSO CHECKED BUTTERFLY ITS FINE. CHEERS TROY
Top
User avatar
Emo
Posts: 4137
Joined: Thu Jan 15, 2004 12:46 pm
Location: Sunshine Coast

Post by Emo »

DGS4WD wrote:Yep, 99.9% sure it will be your TPS (throttle Positioing Sensor). You need to seal it up with a tube a silicon. Did you just give your engine a wash? Is your dual Fuel?
I had this exact problem when I first got my 93 80Series. I would splash through some water and it suddenly wouldn't rev past 2100rpm, drop to idle, nearly stall and then kick back up to 2100rpm again. The next day it would be fine as it would have dryed out buy then. I found that it only happened while running on petrol and NOT LPG so that ruled out a few things.
Good luck.
Where's the TPS and what does it look like. I have the same problem with my 93 80 series.
Top
Post Reply

Return to “Cruiser / Prado”

Who is online

Users browsing this forum: No registered users and 71 guests