Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

GQ Headlight Relay

Tech Talk for Nissan owners.

Moderators: toaddog, V8Patrol

Post Reply
Posts: 11
Joined: Fri Nov 16, 2007 1:34 pm
Location: Rockhampton

GQ Headlight Relay

Post by booga82 »

Just wondering where the headlight relays are located????

Cheers.
Posts: 1187
Joined: Sat Nov 01, 2003 5:05 pm
Location: melbourne, Knoxfield

Post by matthewK »

if its not down next to the driver right leg behind the pannel then it could be in th engine bad next to the battry under the plate
1995 land rover disco on 265 muddies
Posts: 11
Joined: Fri Nov 16, 2007 1:34 pm
Location: Rockhampton

Post by booga82 »

Yeah I checked the relay box and fuse box. Looked all through the engine bay and still can't find them. I swear I'm half retarted.

Cheers.
Posts: 783
Joined: Sat Jul 09, 2005 6:57 pm
Location: geelong

Post by GQ4.8coilcab »

booga82 wrote:Yeah I checked the relay box and fuse box. Looked all through the engine bay and still can't find them. I swear I'm half retarted.

Cheers.
i cant find it either :?
a little hi jack, only one hi beam works when i flick it to high beam, any ideas?????????? replaced globes already
Last edited by GQ4.8coilcab on Fri Nov 16, 2007 4:39 pm, edited 2 times in total.
[color=red][size=150][b]CTRL + W[/b][/size][/color]
Posts: 11
Joined: Fri Nov 16, 2007 1:34 pm
Location: Rockhampton

Post by booga82 »

I think theres only one relay for the high beams so if its buggered neither high beam would come on.

My problem is only the left low beam comes on. All bulbs are fine and both high beams work.

Still can't find the relay though...
Posts: 613
Joined: Fri Oct 21, 2005 9:33 pm
Location: virginia, brisbane

Post by ausoops »

check the plug on the back of the light, it may have slid out of the crimp
swb safari
Posts: 1552
Joined: Wed Dec 22, 2004 12:09 pm
Location: im at wello point

Post by bilby »

front of engine bay drivers side . there is a plate with 2 screws phillips/10mm ( looks like a roofing screw ) they are under that , along with ya a/c engine etc etc ones ;)
just a little left of insanity :)
Posts: 783
Joined: Sat Jul 09, 2005 6:57 pm
Location: geelong

Post by GQ4.8coilcab »

ausoops wrote:check the plug on the back of the light, it may have slid out of the crimp
yer i put the test light through the high beam wire, and the test light comes on really dull. I might just get a set of hi/lo HID kit as they only use one H4 to trigger the high and low beam, $160 on ebay :shock:
[color=red][size=150][b]CTRL + W[/b][/size][/color]
Posts: 80
Joined: Sat Jul 14, 2007 5:41 pm
Location: Sunshine Coast, QLD

Post by terra88 »

GQ4.8coilcab wrote:
booga82 wrote:Yeah I checked the relay box and fuse box. Looked all through the engine bay and still can't find them. I swear I'm half retarted.

Cheers.
i cant find it either :?
a little hi jack, only one hi beam works when i flick it to high beam, any ideas?????????? replaced globes already
mate its your headlight switch... the terminals in the stalk corrode... take it out clean them carefully with some sand paper amd should be all good ...
Its NOT A FORD Its a NISSAN ....

[url=http://www.4wdmonthly.com.au/shed/index.php?id=2292&im=1]92MAV[/url]
Posts: 783
Joined: Sat Jul 09, 2005 6:57 pm
Location: geelong

Post by GQ4.8coilcab »

terra88 wrote:
GQ4.8coilcab wrote:
booga82 wrote:Yeah I checked the relay box and fuse box. Looked all through the engine bay and still can't find them. I swear I'm half retarted.

Cheers.
i cant find it either :?
a little hi jack, only one hi beam works when i flick it to high beam, any ideas?????????? replaced globes already
mate its your headlight switch... the terminals in the stalk corrode... take it out clean them carefully with some sand paper amd should be all good ...
but its only on one headlight? will that make only one highbeam headlight not work? Still gonna try it anyway :)
[color=red][size=150][b]CTRL + W[/b][/size][/color]
Posts: 80
Joined: Sat Jul 14, 2007 5:41 pm
Location: Sunshine Coast, QLD

Post by terra88 »

There is two contacts on the switch for left and right headlights. The same thing happened on my mav and also my terrano (same setup)...

You need to take off the plastic cover when you remove the stalk and as I said just put some sand paper between the contacts and move it around to try and clean them... DONT BEND THE CONTACTS... The stalk comes off easy, just remove the coloum surround and then there is two screws and one plug and its out... easy as...
Its NOT A FORD Its a NISSAN ....

[url=http://www.4wdmonthly.com.au/shed/index.php?id=2292&im=1]92MAV[/url]
Posts: 783
Joined: Sat Jul 09, 2005 6:57 pm
Location: geelong

Post by GQ4.8coilcab »

terra88 wrote:There is two contacts on the switch for left and right headlights. The same thing happened on my mav and also my terrano (same setup)...

You need to take off the plastic cover when you remove the stalk and as I said just put some sand paper between the contacts and move it around to try and clean them... DONT BEND THE CONTACTS... The stalk comes off easy, just remove the coloum surround and then there is two screws and one plug and its out... easy as...
cheers mate, will check it out.
[color=red][size=150][b]CTRL + W[/b][/size][/color]
Posts: 11
Joined: Fri Nov 16, 2007 1:34 pm
Location: Rockhampton

Post by booga82 »

Cleaning the terminals in the stalk/switch fixed it.

Thanks for the help.
Post Reply

Who is online

Users browsing this forum: No registered users and 76 guests