Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

front end noise 80 series

Tech Talk for Cruiser owners.

Moderators: toaddog, Elmo, DUDELUX

Forum rules
Post Reply
Posts: 114
Joined: Mon Mar 28, 2005 9:27 pm
Location: sunny coast qld

Contact:
Contact shavedtoy

front end noise 80 series

Post by shavedtoy »

i have a clunking sort of noise in the front of my 80 when you take off and in low range under load only. any suggestions other than cv's and i have pulled the front tail shaft out and checked it and seems to be fine. any help would be great thanks.
Top
Posts: 128
Joined: Mon Oct 23, 2006 5:29 pm
Location: Melbourne

Post by rezpkt »

CV or centre diff is my guess.
Could even be your crown wheel.. more info would be nice.

what size lift?
Team: Cause For Concern
http://www.offroad80s.com
Top
Posts: 114
Joined: Mon Mar 28, 2005 9:27 pm
Location: sunny coast qld

Contact:
Contact shavedtoy

Post by shavedtoy »

4 inch lift,i have a locker in there too. it started just bitumen driving to work and back. it didn't just start after i had been wheeling and is slowly getting worse.
i am pulling the cv's out to check them but it dosn;t sound like a brocken cv i dont think , i have had a few. i might be wrong. just looking for any other things it may be.
Top
Posts: 667
Joined: Mon Oct 27, 2003 6:26 pm
Location: Redcliffe

Post by Red Rover »

pinion bearing? Pull the shaft out and see how much play is in the pinion flange. While it is out lock the CD in and take it for a drive and see if the noise goes away, that will definitely isolate it to the front end. Other see Duncan at Top Cog and he might be able to figure it out as he is up the coast
Top
Posts: 780
Joined: Wed Apr 26, 2006 7:11 pm
Location: darwin again

Post by simkell »

Red Rover wrote:pinion bearing? Pull the shaft out and see how much play is in the pinion flange. While it is out lock the CD in and take it for a drive and see if the noise goes away, that will definitely isolate it to the front end. Other see Duncan at Top Cog and he might be able to figure it out as he is up the coast
thats what i was thinking
MUD, MUD, GLORIOUS MUD!
Top
Posts: 72
Joined: Fri May 21, 2004 3:14 pm
Location: Sydney

Post by treebruiser »

shavedtoy wrote:i have a locker in there too.
air locker or a lockrite? If it's a lockrite or simular it may be the shear pins, when they let go they sound like a busted CV............
flog the ring out of it
Top
Posts: 114
Joined: Mon Mar 28, 2005 9:27 pm
Location: sunny coast qld

Contact:
Contact shavedtoy

Post by shavedtoy »

air locker, thanks for the feed back
Top
Post Reply

Return to “Cruiser / Prado”

Who is online

Users browsing this forum: No registered users and 96 guests