Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

4JB1T Rear Mail Oil Seal

Tech talk for GMH/Isuzu and Great Wall owners

Moderator: Moderators

Post Reply
Posts: 274
Joined: Tue Nov 16, 2004 7:38 pm
Location: Gosford NSW

4JB1T Rear Mail Oil Seal

Post by rainsey »

Folks,

After a total engine rebuild not 10,000K ago, I have had my truck back in 2 times under warranty for leaking rear main oil seal.

First time the mechanic assumed they nicked it when it went in. The second time, they used a supposedly non genuine product and assumed that it was not tight enough. A 1000K later it is leaking again.

They claim that there is no wear on the drive shaft... so....

Are 4JB1T's inherranty leaky or even after a $6K rebuild, should I expect leaking rear mains?

Maybe I should put a Landrover badge on it so I can justify the oil stains on the driveway.
2in body lift, 2" supension ,33" BGG Muddies, rear ARB Air locker... still scraping the ground!
Posts: 2
Joined: Thu Feb 14, 2008 8:44 pm
Location: portarlington

Post by bluejacka »

these engines are not prone to leaking oil but as a holden mechanic i can tell you that there a special tool to remove and replace the rear main seal on this engine and without using it it would be near impossible to fit it without damaging it
i have seen first hand what damage can be done without using the holden special tool
Posts: 67
Joined: Thu May 13, 2004 6:39 pm
Location: QLD

Post by pig75 »

ISUZU MU's and GEMINI's
[http://pig75.limewebs.com/index.htm]MY SITE[/url]
[color=red]If beef is in beef mince, What is in pet mince?[/color]
Posts: 274
Joined: Tue Nov 16, 2004 7:38 pm
Location: Gosford NSW

Post by rainsey »

O/K An update.

It appears that the turbo, on low revs (idle and up to pribably 1200RPM) is pupming pressure back into the air inlet.

Apparently this pressure is being picked up by the engine breather that connects from the rocker cover to the air inlet and is supplying poitive pressue into the crank case and thus pushing oil out the main oil seal.

Put your hand over the snorkel at idle and you can fill positive pressure.

Stay tuned for the next installment as to how an rodeo and destroy my bank balance.
:twisted:
Cheers

rainsey
2in body lift, 2" supension ,33" BGG Muddies, rear ARB Air locker... still scraping the ground!
Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests