Hello,
I bought a vitara wreck with 1.6efi engine to put in the zook.
However it is missing a few parts so I had a few questions.
The dizzy is missing .. Will any G16 dizzy fit (8v carby or 16v efi)? or even pushing it the 1.3 carby one? if not are there any identifying marks on the efi one or extra bits i an notice when looking for one at the wreckers? I saw one today but it only had g16 written on it so i didnt get it just in case.
The alternator is missing (i think bracket is there)... do i need to use the vitara ones or can i use the sierra one ... or an alternative?
The exhaust was missing (am getting extractor anyway) so i will need an o2 sensor. Do i need to get a specific one or are they generic?
The timing case is broken, can you get new ones? if so where?
The fan is missing ... can i use the 1.3L fan or should i just get a thermo?
Thanks in advance
Terrence
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
missing 16V parts
Re: missing 16V parts
*Not sure about the dizzy.
*EF Falcon alt almost bolts straight on and is much bigger in capacity and cheaper than a Zook alt.
*Check to see if you have a 1, 2 or 3 wire O2 sensor.
*Timing cover.... www.lowrangeoffroad.com US$27
*Thermo fan/s will not do anywhere near the same job as an engine driven fan and shroud.
*EF Falcon alt almost bolts straight on and is much bigger in capacity and cheaper than a Zook alt.
*Check to see if you have a 1, 2 or 3 wire O2 sensor.
*Timing cover.... www.lowrangeoffroad.com US$27
*Thermo fan/s will not do anywhere near the same job as an engine driven fan and shroud.
looks like i have the bottom bracket for the alt not the long adjustable bit. Do i need to get one or can i make one up from steel?
The whole dizzy is missing (hole in back of head and no leads from coil to engine). What models of swift can i get it out of?
Can I use the original fan and shroud and radiator of the 1.3?
There was a plug hanging down near where the exhust would have been ... it was a four point connector but only had three wires going into it. The connector had a black sorround with orange internals... the colours on the wires dont line up with heated oxygen sensor on the wiring diagram i have though.
The whole dizzy is missing (hole in back of head and no leads from coil to engine). What models of swift can i get it out of?
Can I use the original fan and shroud and radiator of the 1.3?
There was a plug hanging down near where the exhust would have been ... it was a four point connector but only had three wires going into it. The connector had a black sorround with orange internals... the colours on the wires dont line up with heated oxygen sensor on the wiring diagram i have though.
Who is online
Users browsing this forum: No registered users and 2 guests