hi guys
i'm in need of a new drag link and would like to know if anyone has made there own draglink useing hemie joints???
i would also like to know with steel size did you use and what hemie joints did you use.....oh don't for get to post up pic's of your set up
Nat
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
hemie joint draglink
Moderators: toaddog, TWISTY, V8Patrol, Moderators
hemie joint draglink
Tires are like boobs, they always look big until you have played with them for a while, then you just want a bigger set
BerettaHEIM joints (AKA Rose joints or rod ends) are a bit of a minefield - They're illegal for road use, and thre are a gazillion grades and qualities.
Why do you specifically need heim joints?
They're not generally designed for the kind of angles and environment under a car and tend to have a short life. It's not commonly known thay they generally permit less angle "out of phase" than the stock ball joints and wear much more quickly, making them noisey and clunky. Angle can be increased with spacers, but this will seriously reduce the strength of a single shear connection (like at the pitman arm)
They are also not really designed for single shear mounting (like a ball joint) so the bolted connection needs to be very well designed to make the connection strong enough.
Personally, I'd be trying to avoid using them in a steering system at all for a car used on the road.
Just my 2C
Steve.
[quote="greg"] some say he is a man without happy dreams, or that he sees silver linings on clouds and wonders why they are not platinum... all we know, is he's called the stevie.[/quote]
I run 3/4" heims all throughout my steering and have for several years without an issue. No wear, no noise, and very reliable. Plenty of misalignment for my five feet of flex(I just start to max out the right knuckle drag link end at full droop, remember I have lh drive).
Just make sure that you don't scimp in any way with steering componants, get the best that you can find and go overkill size.
To answer your question, I run 3/4" with 3/4"-16 shank, 1.5"d .25"wall DOM tube. My steering arms arm 1.5" thick 4130 steel in a single sheer with grade eight bolts with lock nuts.
You should also keep in mind local laws like was said earlier. If it isn't legel, run 1ton tie rod ends...
Just make sure that you don't scimp in any way with steering componants, get the best that you can find and go overkill size.
To answer your question, I run 3/4" with 3/4"-16 shank, 1.5"d .25"wall DOM tube. My steering arms arm 1.5" thick 4130 steel in a single sheer with grade eight bolts with lock nuts.
You should also keep in mind local laws like was said earlier. If it isn't legel, run 1ton tie rod ends...
better to look the fool then to open your mouth and remove all doubt :flippoff:
Who is online
Users browsing this forum: No registered users and 123 guests