hi guys i recently bought a 2004 hilux dual cab, it has split rims and dunlop tyres pissy little road tyres.
i bought a set of bfg mud terrain 32 11.5 r15 wit sunraysia rims (ebay job).
problem is wen i put them on my ute the 2 front tyres were rubbing the inside of the guards at the bottom near the side steps.
i need advice as 2 wat 2 do, apart from getting rid of the rims and tyres and starting fresh.
i was told that i 2inch lift should do the trick.
the ute currently still has all the factory suspension and wat not.
any suggestions ??
cheers hamerz.[/i][/b]
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
need advice please.
Moderators: toaddog, Elmo, DUDELUX
Is the offset on both sets of rims the same?
is the distance from the center of the rim (where it bolts to your hub) to the dege of the rim/tyre on the inside edge (where its closest to your engine bay a similar distance, bit hard to explain but what im asking is if the inside edge of the rim is closer to the body of your vehicle becaise the rim offset is wrong, or if its simply because the bigger diameter tyre is now up in the guard where it starts to curve in? If the offset has changed too much then they might just not fit. If its just that the diameter is bigger then a body lift should help, if the offset is the issue then a body lift will not help.
Someone might be able to offer clearer advice, if you cant understand my juble of words?
is the distance from the center of the rim (where it bolts to your hub) to the dege of the rim/tyre on the inside edge (where its closest to your engine bay a similar distance, bit hard to explain but what im asking is if the inside edge of the rim is closer to the body of your vehicle becaise the rim offset is wrong, or if its simply because the bigger diameter tyre is now up in the guard where it starts to curve in? If the offset has changed too much then they might just not fit. If its just that the diameter is bigger then a body lift should help, if the offset is the issue then a body lift will not help.
Someone might be able to offer clearer advice, if you cant understand my juble of words?
Who is online
Users browsing this forum: No registered users and 0 guests