Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Ford Xflow temp sender

General Tech Talk

Moderators: toaddog, TWISTY, V8Patrol, Moderators

Forum rules
Post Reply
Posts: 101
Joined: Mon Jan 23, 2006 7:08 am
Location: Mt. Tamborine QLD

Contact:
Contact Maria

Ford Xflow temp sender

Post by Maria »

Hi, I am putting a Ford 4.1 lt crossflow engine into my Willys truck. Can any one tell were the temp sender is located on the head, it is a cast iron head, from a XC or XE. I bought a sender from Repco, so it must go somewere.
Thanks
www.mucanvasproducts.com
www.brisbanejeepclub.com
Top
Posts: 33
Joined: Fri May 26, 2006 9:55 pm
Location: Victoria

Post by xl7fan »

G'day, I have an alloy head XE & it's located at the front R/H down the bottom. May be the same for cast head.
Matt 2001 XL7. OME 2" lift, Cooper ATR's, TJM alloy bar, Piranha Dual battery setup, Command cruise control, Viper alarm, Uniden UHF.
Top
Posts: 101
Joined: Mon Jan 23, 2006 7:08 am
Location: Mt. Tamborine QLD

Contact:
Contact Maria

Post by Maria »

Thanks we look but it is not.
www.mucanvasproducts.com
www.brisbanejeepclub.com
Top
User avatar
WOZ
Posts: 61
Joined: Wed Nov 22, 2006 8:20 pm
Location: brisbane, northside

Contact:
Contact WOZ

Post by WOZ »

The temp sender is located at the rear of the cyl head on the inlet side and is 1\8bsp thread.
Top
Posts: 101
Joined: Mon Jan 23, 2006 7:08 am
Location: Mt. Tamborine QLD

Contact:
Contact Maria

Post by Maria »

Thanks WOZ we will look there. This head seem to not have a sender spot for it. Cast iron head.
www.mucanvasproducts.com
www.brisbanejeepclub.com
Top
Posts: 3940
Joined: Wed Dec 27, 2006 1:09 pm
Location: Sunshine Coast Qld

Post by want33s »

Image
Top
Posts: 101
Joined: Mon Jan 23, 2006 7:08 am
Location: Mt. Tamborine QLD

Contact:
Contact Maria

Post by Maria »

Thanks for picture, will look over the weekend if is there. Cheers, Maria
www.mucanvasproducts.com
www.brisbanejeepclub.com
Top
Post Reply

Return to “General Tech”

Who is online

Users browsing this forum: No registered users and 0 guests