Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Rotating a high mount winch motor

General Tech Talk

Moderators: toaddog, TWISTY, V8Patrol, Moderators

Forum rules
Post Reply
Posts: 286
Joined: Tue May 11, 2004 8:48 pm
Location: Toowoomba

Rotating a high mount winch motor

Post by patrol man »

I have been working on fitting a high mount to my GU factory steel bull bar.
For this all to work out I am planing on mounting the winch backwards, by welding new mounts to the back of the gear box this will leave the motor to stick up through the bar top. If I could rotate the motor 90" it will fit nicely. with out cutting the top of the bar. The motor I have will not allow this as the bolts fowl the winding wiring and there is no threaded holes at 90" like the low mounts I have seen, so do other motors (4.6 or 6 horse) allow for the mounting bolts to pass through the windings at 90" or only at the set 180"
Living the dream on the hill that floods
Top
Posts: 574
Joined: Wed Aug 17, 2005 11:49 am
Location: NZ

Post by nzdarin »

All the motors that I have only allow 180* mounting.
They are
2.5hp 12v Warn
4.6hp 12v Warn
6hp 12v Warn
7.8hp 24v Superduty.

They all mount the same. To rotate you just need to shift the locating pin.
93 Nissan Pathfinder / Terrano Turboed VH45, GQ Trans and T-case, coil overs, hydraulic winch and fair bit of other stuff. (Currently a pile of parts in the workshop)
Top
Posts: 58
Joined: Thu Mar 06, 2008 9:32 pm
Location: Spring Farm

Post by AZZA FJ40 »

the problem you will have will be the brake operation, unless when you spin it you come off the top of the drum instead of the bottom.
1981 SWB FJ40
Top
Posts: 782
Joined: Tue Mar 08, 2005 12:03 pm
Location: brisbane

Post by giantracing »

AZZA FJ40 wrote:the problem you will have will be the brake operation, unless when you spin it you come off the top of the drum instead of the bottom.
spot on. ill swap you a low mount 9.5 for a hi mount
build em tuff, drive em ruff.........

Custom 4wd Creations Brisbane
0438279890
Top
Post Reply

Return to “General Tech”

Who is online

Users browsing this forum: No registered users and 151 guests