Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

More spotties

Tech Talk for Mitsubishi owners.

Moderator: -Scott-

Forum rules
Post Reply
Posts: 79
Joined: Thu Oct 25, 2007 7:43 pm
Location: Hunter Valley

More spotties

Post by 4x4 suzi »

Hi
ok i have a 97 paj and put 2 narva spotties on the bull bar, i do a fair bit of night driving in the country and was looking at getting more. thinking about on the top bar of the bull bar? anyone done some strap on mounts up there before? because the bottom rail alrady had tabs but the top doesnt. it is an alloy bar so i would be hard to get some welded on right?
Top
Posts: 79
Joined: Thu Oct 25, 2007 7:43 pm
Location: Hunter Valley

Post by 4x4 suzi »

This is the spotties and want to put 2 the same above these ones on the top fat rail

Image
Top
Posts: 51
Joined: Sun Mar 11, 2007 12:25 pm
Location: Melbourne

Post by simmo404 »

I reckon you should put some spreaders on your roof rack if its strong enough. Better perpheral vision for roos.
Top
Posts: 79
Joined: Thu Oct 25, 2007 7:43 pm
Location: Hunter Valley

Post by 4x4 suzi »

yea i was thining that. were do people run their wire without looking dodgy?
Top
Posts: 80
Joined: Tue Sep 06, 2005 6:24 pm
Location: sydney

Post by eddy 76 »

mate I had extra tabs welded on my alloy bar for 15 bucks each. that was at formula offroad in sydney but you should be able to find somone to do it look for a truck body builder.

cheers eddy
Top
Posts: 14668
Joined: Mon Aug 29, 2005 7:10 pm
Location: western shitney

Post by j-top paj »

eddy 76 wrote:mate I had extra tabs welded on my alloy bar for 15 bucks each. that was at formula offroad in sydney but you should be able to find somone to do it look for a truck body builder.

cheers eddy
what he said ;)
Banzy wrote:Dial up internet.........you'd post something and come back 2 beers later to see if it loaded.
my GU
Top
Posts: 52
Joined: Wed Dec 12, 2007 8:05 am
Location: Edgeworth

Post by dig3283 »

you could always go to super cheap or dick smith and get cb aerial mounts for your bull bar and use them they strong enough and do the job and easy to fit or remove them if you dont want them there. just measure your bull bar and pick the right one it comes with to u bolts so it a pinch of piss
Top
Post Reply

Return to “Mitsubishi”

Who is online

Users browsing this forum: No registered users and 9 guests