Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

engine problems

Tech Talk for Suzuki owners.

Moderators: lay80n, sierrajim

Post Reply
Posts: 43
Joined: Wed Apr 16, 2008 9:29 pm
Location: Tassie

engine problems

Post by Mike E »

I've been fixing a few bits and pieces since i got my zook and well i finally got to the motor so i got a mate to give me a hand. we set the timing and tuned it up and got it running real nice then we adjusted the valves and thats where my problem started i bolted the valve cover back on and went to start it and it just wouldn't start so i checked the valves again and tried it again and still didn't start. it wasn't turning over the best so i thought it might of been the battery so i replaced that and that didn't really help now i think the starter motor has had it because it grinds and only works half time. has anyone had similar problems? i'm new to this sort of stuff so any help or advice would be muchly apreciated

Cheers
Mike
Posts: 255
Joined: Mon Jan 21, 2008 2:22 pm
Location: Brisbane

Post by Bruceh »

You sure no one put the dizzy in the wrong way.
"Team Casper"
Go the mighty Zook
The only motor sport we spend money on to go slower.
Posts: 43
Joined: Wed Apr 16, 2008 9:29 pm
Location: Tassie

Post by Mike E »

we set the timing to what it said on the bonnet then didn't touch it after that
Posts: 176
Joined: Tue Dec 11, 2007 10:10 pm
Location: Perth

Post by scooby_74 »

If the starter is grinding, replace it, will have to in a short time anyhow.
zuks seem to need a good crank speed to fire up.
Check the fuel pump is pumpig fuel to the carby, seen them fail regularly when the vehicle has sat for some time.
Fail that feed 12v direct to the + side of the coil ign volt drop can slow there start aswell
93 NJ,5 speed,2" body lift,32" muddies

There's nuttn like momentum
Posts: 43
Joined: Wed Apr 16, 2008 9:29 pm
Location: Tassie

Post by Mike E »

i checked and its getting plenty of fuel i also checked with an old plug and it didn't seem to be getting much spark but the battery is new i read something somewhere that sierras don't get enough power through the ignition or something like that, could that have something to do with my problem?
Posts: 3513
Joined: Tue Feb 15, 2005 12:52 am
Location: Perth, WA

Post by alien »

the grinding may also be the ring gear - i wore mine out once before, you can actually just flip it around too, rather than getting a wrecked one.
The worst thing about censorship is ███████.
Posts: 43
Joined: Wed Apr 16, 2008 9:29 pm
Location: Tassie

Post by Mike E »

i checked the ring gear and most of it is in good condition it just doesn't want to turn over the motor itll grind then stop then grind and every so often it'll turn over the motor like half a turn
Post Reply

Who is online

Users browsing this forum: No registered users and 3 guests