Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Tyre Tube Size

General Tech Talk

Moderators: toaddog, TWISTY, V8Patrol, Moderators

Forum rules
Post Reply
Posts: 148
Joined: Fri Dec 29, 2006 9:22 pm
Location: Melbourne

Tyre Tube Size

Post by juls »

Following on from my thread

http://www.outerlimits4x4.com/ftopic142448.php

I would like to get any general advice regarding what size tubes should be fitted in tyres and how it might effect things wiht undersize tubes.

Also any thoughts on why my tyres are rotating on the rim at 25psi and what action can be taken (besides beadlocks) to remedy this.

My tyres are 285 85 16 with 7.0/7.5 x 16 tubes.
Top
Posts: 3940
Joined: Wed Dec 27, 2006 1:09 pm
Location: Sunshine Coast Qld

Post by want33s »

A standard 16" tube should be fine but why not run them tubeless?

If the tyres are slipping on the rims it is most likely because the wrong compound(slippery stuff) was used to fit them.
If you use detergent they will slip at reduced pressures.
Top
Posts: 148
Joined: Fri Dec 29, 2006 9:22 pm
Location: Melbourne

Post by juls »

They are a tube type tyre.

It has been suggested a few times they may have been fitted using the wrong compound like you say.

Will investigate further and attempt to clean the bead too.
Top
Post Reply

Return to “General Tech”

Who is online

Users browsing this forum: No registered users and 26 guests