Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
GQ Wipers wont stop
Moderator: -Scott-
GQ Wipers wont stop
The hi and low speeds work normaly but when it is on intermittant or off it like it is on int but with only about a half a second break between cycles. I thougt it was the relay in the amp sticking so i pulled it out and gave it a little tap and put it back and it fixed it for about 10 mins than it started doing it again. so i got another amp but it is still doing it. I have also tried a new switch, didnt fix it either. has anybody else had this problem, is it possible that it could be the motor, hoping to find an easy answer before i go searching thru the whole loom trying to fix it.
Tow Rig - 4.2 Turbo Deisel GQ. 5in coils, 2in body, f&r tube bars, sliders, 35's.
Comp Truck - Sierra, ute chop, G16B, 6.5 xfer, exo cage, 34 JT II's, 3/4 eliptical rear, SPOA, 2in body.
Comp Truck - Sierra, ute chop, G16B, 6.5 xfer, exo cage, 34 JT II's, 3/4 eliptical rear, SPOA, 2in body.
thanks for the advice. pulled the motor out and checked out the tracks. gave it a clean and i seem to have good contact. Didnt fix the problem.
Tow Rig - 4.2 Turbo Deisel GQ. 5in coils, 2in body, f&r tube bars, sliders, 35's.
Comp Truck - Sierra, ute chop, G16B, 6.5 xfer, exo cage, 34 JT II's, 3/4 eliptical rear, SPOA, 2in body.
Comp Truck - Sierra, ute chop, G16B, 6.5 xfer, exo cage, 34 JT II's, 3/4 eliptical rear, SPOA, 2in body.
Who is online
Users browsing this forum: No registered users and 1 guest