Just wondering if anyone can give advice on adjusting the valve clearances. I have done this before on other vehicles and have the
feroza bible handy to tell me the ranges of adjustment when hot and
cold.....my question's are:
(1) does this engine prefer erring on the tighter
or looser side for the valves? and
(2) does anyone recommend a particular clearance?
cheers, Ben.
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
valve clearances
Moderator: Tiny
IMO setting with feelers is very subject to user "feel" and varies substantially.
Unfortunately few use a micrometer to develop experience in what the correct "feel" is - so the clearances vary substantially.
I always seem to get a better job when done cold as its a pita when its hot and to do it quickly enough is a challenge.
IIRC the cold clearance is tighter than the hot ( the head expands more than the valve ) so therefore they seem to like it tighter than looser.... but there's a limit of course and I always use the factory recommended clearance...
Just my opinion of course.
Unfortunately few use a micrometer to develop experience in what the correct "feel" is - so the clearances vary substantially.
I always seem to get a better job when done cold as its a pita when its hot and to do it quickly enough is a challenge.
IIRC the cold clearance is tighter than the hot ( the head expands more than the valve ) so therefore they seem to like it tighter than looser.... but there's a limit of course and I always use the factory recommended clearance...
Just my opinion of course.
( usual disclaimers )
It seemed like a much better idea when I started it than it does now.
It seemed like a much better idea when I started it than it does now.
I tried doing them "hot" on my old Charade and it was a right PITA because tightening the locking nut causes the clearance to vary 
and of course the engine was cooling while I was stuffing around. I left the Feroza to a mechanic....
Be careful of the top alloy cam cover as they're easy to break.
and of course the engine was cooling while I was stuffing around. I left the Feroza to a mechanic....Be careful of the top alloy cam cover as they're easy to break.
David
Who is online
Users browsing this forum: No registered users and 3 guests