Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

My brake lights don't work

For all things Electrical.

Moderator: -Scott-

Post Reply
Posts: 221
Joined: Mon Oct 28, 2002 9:05 pm
Location: Jimboomba, QLD

My brake lights don't work

Post by SNAFU! »

My brake lights aren't working, only tail lights. Could it be the switch above the brake pedal???? I have checked fuses and earths and everything is ok :?:
Whats up!!
Posts: 943
Joined: Sun Aug 24, 2003 2:42 pm
Location: Launceston

Post by Bluey »

is it both sides?
yes then look for fault in wiring further up from lights, maybe connectors and broken wire? (scrape over rock recently?) could be switch or wire feed to switch.
no then most likely fault at tail end
Posts: 221
Joined: Mon Oct 28, 2002 9:05 pm
Location: Jimboomba, QLD

Post by SNAFU! »

Yeah, i will have a good look 2morrow
Whats up!!
Posts: 223
Joined: Sat Sep 27, 2003 5:10 pm
Location: NW Sydney, NSW

Brake light switch

Post by Impulsive »

I'd also be checking out the switch at your brake pedal, Take the wires off the switch and alternately short, then open the connection between the two while somebody looks at the lights for ya.
1998 Vitara Hard Top 2.0 EFI
65mm springs (by Allsprings)
35mm body lift
Rancho RS9000's
235's on 15in alloys
Flipped strut mounts
Posts: 4760
Joined: Mon Dec 30, 2002 6:04 am
Location: Adelaide

Re: Brake light switch

Post by murcod »

Impulsive wrote:I'd also be checking out the switch at your brake pedal, Take the wires off the switch and alternately short, then open the connection between the two while somebody looks at the lights for ya.


No need to disconnected the wires to short them- just short out the switch with a screwdriver/ short piece of wire or something similar.

Also have a close look at the wires where they're joined to the switch, one vehicle I had they were soldered onto the switch and had come loose.
David
Post Reply

Who is online

Users browsing this forum: No registered users and 11 guests