Hi Guys
I have a '85 FJ73 landcruiser
Shortly after starting the car, and driving all of 10 mins the temp gauge hit the top and stayed there.
I stopped and checked the radiator and it was warm but not boiling hot.
Would this be normal behavior for a faulty temp sender unit?
Cheers
Matt
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Faulty Temp sender unit?
Moderator: -Scott-
The temperature gauge is actually a milliampmeter. As the temperature in the sender unit increases, the resistance drops and you get more current through the meter - hence the gauge reads higher. The gauges are normally powered by a separate power supply - typically 5 Volts. A high reading means that the resistance is low - either by a stuffed sensor, or by a short in the wiring to the sensor. Or you could have a stuffed power supply (voltage too high).
The first thing I would check would be the resistance of the sender. Your manual will probably have the resistance in the specs. It varies with temperature, but if you check if when the engine is cold, it should probably read about 200 ohms, dropping to about 10 ohms when it is hot (85 Deg C). The actual values will vary with the type of car etc, but this gives some idea.
The take the lead off from the sender and see if the gauge moves. If it still moves, you have a short somewhere. Whilst is is off the sender, check the voltage - it is normally not 12 V but much less eg 5 V.
The first thing I would check would be the resistance of the sender. Your manual will probably have the resistance in the specs. It varies with temperature, but if you check if when the engine is cold, it should probably read about 200 ohms, dropping to about 10 ohms when it is hot (85 Deg C). The actual values will vary with the type of car etc, but this gives some idea.
The take the lead off from the sender and see if the gauge moves. If it still moves, you have a short somewhere. Whilst is is off the sender, check the voltage - it is normally not 12 V but much less eg 5 V.
it worked perfectly yesterday and for the last 5 years I replaced it once when I replaced the thermostat housing (as the old one was stuck in)-Scott- wrote:Completely wrong characteristics (mismatched to the gauge) could cause something like that. I suppose a dud could do similar. It used to work OK?
Who is online
Users browsing this forum: No registered users and 3 guests