Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
putting a disy in
Moderators: toaddog, TWISTY, V8Patrol, Moderators
putting a disy in
I no this is not a 4wd but im having truble putting a disy back in to a A4 toyota WITH out a manual
point the rotor in the position of no. 1 lead and have the engine at top dead center no.1 cyl compression stroke and slot it in as it goes in the shaft will turna little and it may be nessesary to pull it up just so the gear and shaft can be turned back 1 tooth
Hope that helps
Allan
Hope that helps
Allan
http://www.4wdaction.com.au/shed/index.php?id=1097&im=1
[quote="squik"]He He... every time I turn off my protection my box gets slammed with spam....
[/quote]
[quote="squik"]He He... every time I turn off my protection my box gets slammed with spam....
[/quote]
Who is online
Users browsing this forum: No registered users and 38 guests