Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

75-60

Tech Talk for Cruiser owners.

Moderators: toaddog, Elmo, DUDELUX

Forum rules
Post Reply
Posts: 2347
Joined: Sat Jan 27, 2007 12:56 pm
Location: Perth

75-60

Post by Z()LTAN »

Will my 75s HP center fit in a 60s housing?

Will my 75s ball ends fit in the 60s housing so i can use all my new 75s hubgear and longfeilds?
Locktup4x4.com.au - For all of your hardcore gear

Outlaws4x4.com
Top
Posts: 1109
Joined: Mon Feb 12, 2007 8:48 pm
Location: Australia

Post by hulsty »

The centre wont, the HP diff is a smaller diff than the 60 series low pinion front which is the same as your rear. Maybe if you used some kind of adaptor?


What kind of longfields are they? if they are 40 series ones they will fit straight into the 60 series balls you will just need the correct axels/length
Top
Posts: 1109
Joined: Mon Feb 12, 2007 8:48 pm
Location: Australia

Post by hulsty »

what are you trying to do by running the 60 front diff assembly? strength? width or something else?

cheers
Top
Posts: 2347
Joined: Sat Jan 27, 2007 12:56 pm
Location: Perth

Post by Z()LTAN »

the wider housing, the round axle tube

Be alot easier...
Locktup4x4.com.au - For all of your hardcore gear

Outlaws4x4.com
Top
Posts: 2347
Joined: Sat Jan 27, 2007 12:56 pm
Location: Perth

Post by Z()LTAN »

The only reason i want to keep the front dif and hubs is that they are all new and ive spent some good dosh on them b4 i knew better...

I spose ill run with it for now till something goes..
Locktup4x4.com.au - For all of your hardcore gear

Outlaws4x4.com
Top
Posts: 1109
Joined: Mon Feb 12, 2007 8:48 pm
Location: Australia

Post by hulsty »

I think the hubs should work fine on the 60 series housing, i'm using IFS hilux hubs on 70 series stub axels with 70 series discs and the free wheeling hubs were from a 60. Check the wheel bearing sizes to so if your later hubs will work on the 60 series stub axels
Top
Posts: 15549
Joined: Tue Oct 22, 2002 9:23 am
Location: Your Mummas House!

Contact:
Contact bj on roids

Re: 75-60

Post by bj on roids »

Z()LTAN wrote:Will my 75s HP center fit in a 60s housing?

Will my 75s ball ends fit in the 60s housing so i can use all my new 75s hubgear and longfeilds?
NOPE!

YEP, if you cut the tubes and press it in! :crazyeyes:
hands and mums dont count!!!
Top
Post Reply

Return to “Cruiser / Prado”

Who is online

Users browsing this forum: No registered users and 2 guests