Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Exhaust cover plates

General Tech Talk

Moderators: toaddog, TWISTY, V8Patrol, Moderators

Forum rules
Post Reply
Posts: 5714
Joined: Fri Nov 22, 2002 3:55 pm
Location: Perth WA.

Exhaust cover plates

Post by nicbeer »

Hey,

I got a 05 subaru forester NA and got an annoying noise coming from where i have pinpointed it so far down to the tin covers over the exhaust.

what are these for? and ok to take em off? i would say so yes as any aftermarket exhaust does not have them on.
[url=http://www.outerlimits4x4.com/viewtopic.php?p=930942#930942&highlight=]Zook[/url]
U SUK Zook Built and Sold.
New rig is 97 80 DX. 2" list 33s
Top
Posts: 2254
Joined: Tue Dec 10, 2002 5:09 pm
Location: Sydney

Contact:
Contact jessie928

Post by jessie928 »

its a heatsheild.

it may be protecting wireing of hoses.
but mostly it is to shop exhaust heat heating up the floor of the car.

Jes
ATTACH BROKEN TOYOTA HERE--->
DUCATI <-----Worlds best warning label
Top
User avatar
Guy
Posts: 10366
Joined: Thu Dec 12, 2002 8:43 am
Location: Wangaratta

Re: Exhaust cover plates

Post by Guy »

nicbeer wrote:Hey,

I got a 05 subaru forester NA and got an annoying noise coming from where i have pinpointed it so far down to the tin covers over the exhaust.

what are these for? and ok to take em off? i would say so yes as any aftermarket exhaust does not have them on.
I would leave them where they are, they reflect and carry to areas it can be safley disapated an amazing amount of heat.

It should not be to hard to recitify the issue instead of just ditching the heat sheilds.
" If governments are involved in the covering up the knowledge of aliens, Then they are doing a much better job of it than they do of everything else "
Top
Posts: 5714
Joined: Fri Nov 22, 2002 3:55 pm
Location: Perth WA.

Post by nicbeer »

roito i will have a look.

borrowing some car ramps this weekend.

its only a cover about 200mm long covering the collector where the pipes converge, i will have a double check whats above it also for wiring/hoses.
[url=http://www.outerlimits4x4.com/viewtopic.php?p=930942#930942&highlight=]Zook[/url]
U SUK Zook Built and Sold.
New rig is 97 80 DX. 2" list 33s
Top
Posts: 3038
Joined: Thu Aug 05, 2004 10:06 pm
Location: VIC

Post by dogbreath_48 »

Hit it with a hammer till it stops making noise - shouldn't take much.
Tetanus rolling on 37's
Top
Posts: 4330
Joined: Tue Jun 08, 2004 6:06 pm
Location: Central Victoria

Contact:
Contact coxy321

Post by coxy321 »

dogbreath_48 wrote:Hit it with a hammer till it stops making noise - shouldn't take much.
Yep, i did the same. I checked over for loose bolts/nuts and washers too.

All fixed.
Top
Posts: 38
Joined: Wed Feb 21, 2007 1:15 pm
Location: Burra NSW

Post by Burra Boy »

The Forester has a bad habit of cooking the CV joint rubber boot with the heat from the exhaust. I'd be very careful about removing heat shields - they are there for a reason!!
Burra Boy. 1x 89 LWB wagon, turbo, frozenboost IC, lots of stuff. 1X 90 leafie ute, AXT turbo, tough as nails and about as comfie...
Top
Post Reply

Return to “General Tech”

Who is online

Users browsing this forum: No registered users and 124 guests