Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
1 ltr carbie rebuild questions
1 ltr carbie rebuild questions
does anyone no a web site were i can get a manual on rebuilding my carbie its one of the side draft ones that came on the f10a or is there is there a thread on here about it ?????? my carbie is pissin out so any help would b great coz i wanna do it tomoro at work
Posts: 242
Joined: Wed Jul 11, 2007 9:38 am
Joined: Wed Jul 11, 2007 9:38 am
Location: stuck in a hole. not offroad, just deception bay
mate theres not much to em. just lay it out on a clean bench as you pull it apart. the jet/emulsion tube etc.. will only go in one place so you cant mix it up. float gets set from 10mm in from the bottom corner of the float to the bottom side of the sealing surface (without gasket) think its about 42mm but i'll get back to you with the definate correct float level and try and get you a pic too.
once I rebuilt my 1 litre carby I have never had any problems with it stalling from angles or being hard to srart on angles. they are a great standard setup.
once I rebuilt my 1 litre carby I have never had any problems with it stalling from angles or being hard to srart on angles. they are a great standard setup.
Posts: 242
Joined: Wed Jul 11, 2007 9:38 am
Joined: Wed Jul 11, 2007 9:38 am
Location: stuck in a hole. not offroad, just deception bay
Who is online
Users browsing this forum: No registered users and 1 guest