Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

H55F - location of reverse light switch and connecting it to

Tech Talk for Cruiser owners.

Moderators: toaddog, Elmo, DUDELUX

Post Reply
Posts: 78
Joined: Fri Dec 12, 2008 6:23 am
Location: Hobart, Tasmania

H55F - location of reverse light switch and connecting it to

Post by twr7cx »

Anyone know where I'd find the reverse light switch on an H55F gearbox?
Last edited by twr7cx on Wed Mar 04, 2009 10:00 am, edited 1 time in total.
Posts: 1031
Joined: Sun May 01, 2005 10:22 pm
Location: Newcastle 2300

Post by joel HJ60 »

Taking a guess... as I can't see it in either of my manuals.


It should be on the gearbox, rear and I'm thinking right hand side. OR at the front on top of the top cver.
[b]1985 HJ60[/b]

[url]http://forum.ih8mud.com/60-series-wagons[/url]
Posts: 1383
Joined: Tue May 06, 2008 8:12 pm
Location: Newcastle

Post by oldmate »

it is on the top, at the front, and it's to the driver side edge, quite close to it. You should be able to see the wiring coming from the engine bay and running to it. I suspect you may have to lower the gearbox some to get to it.
Posts: 15549
Joined: Tue Oct 22, 2002 9:23 am
Location: Your Mummas House!

Post by bj on roids »

Pull your tunnel cover off, and put it in reverse, you will SEE the switch if you follow the shifter and look. there is a tiny plug and two wires.
hands and mums dont count!!!
Posts: 78
Joined: Fri Dec 12, 2008 6:23 am
Location: Hobart, Tasmania

Post by twr7cx »

cheers, finally going to get around to doing this. reason why I was asking is because I'm wiring up some tail lamps. ATM there's no wires going to the rear of the vehicle for the reverse lamps. No idea why but hopefully by this afternoon that shouldn't be the case.
Posts: 78
Joined: Fri Dec 12, 2008 6:23 am
Location: Hobart, Tasmania

Post by twr7cx »

Is this it? It's on the drivers side just next to the chasis rail:

Image
Image

The only other thing I can find which could be it is (but this is on the passenger side on the bell housing):

Image
Image
Image
Image


There's no plug anywhere near it for it to connect to, so I guess I'll have to chop the plug off and wire it up. Anyone know which wire should go to where? I assume 1 should go to the reverse light and the other to an switched positive power source.
Resident Terrorist
Posts: 4278
Joined: Fri May 21, 2004 9:37 am
Location: Driving Barnsey's mum to bingo

Post by RAY185 »

That blue plug looks like the 4wd activation light sender (for models that had a 4wd light on the dash). If you follow the wires back on that blue plug it will go to the transfer case, near the 2wd/4wd lever. The wiring you are chasing is attached to the gearbox, not transfer. You should find it at the top of the gearbox, right at the front where it meets the bellhousing. As said, you may have to pull the tunnel cover off to see it.
Posts: 78
Joined: Fri Dec 12, 2008 6:23 am
Location: Hobart, Tasmania

Post by twr7cx »

Done, lights are lighting up now (which is a good thing for lights to be doing).
Post Reply

Who is online

Users browsing this forum: No registered users and 70 guests