Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
any one have a v6 tick tick tick tick tick?
Moderator: -Scott-
any one have a v6 tick tick tick tick tick?
hey chaps
i have a v6 3.5 1996 paj long wheel base
and i have a tick tick tick coming from the eng head.
i was thinking tapets? may be.... i tried putting some tappet free up oil in , but i think it just sounds worse to be honest... i dont think its harming my eng but its just annoying and makes me feel like it drives like shit.. ha ha.
if it is my tappets can they be ajusted or are they gone and need replaced?
cheers
i have a v6 3.5 1996 paj long wheel base
and i have a tick tick tick coming from the eng head.
i was thinking tapets? may be.... i tried putting some tappet free up oil in , but i think it just sounds worse to be honest... i dont think its harming my eng but its just annoying and makes me feel like it drives like shit.. ha ha.
if it is my tappets can they be ajusted or are they gone and need replaced?
cheers
It could due to the oil you are running or the tappits are partly blocked, I have seen a procedure where you have rev the motor a number of times and this helps .
Also do a search of this forum
http://www.pajeroclub.com.au/home/publicforum/
Also do a search of this forum
http://www.pajeroclub.com.au/home/publicforum/
Mate when I got my 3.0 NH many moons ago it had 102,000K's and clicked like hell.
I added a dose of Slick 50 and about every 10,000K's or so it would start to click again so I added the Nulon lfter quiet stuff which would work for another 10,,000K's.
It's worth a try before to replace the tappets and spend a lot of $$$.
Also a good oil change may help at the same time.
It's a common problem with these motors so your not alone.
I added a dose of Slick 50 and about every 10,000K's or so it would start to click again so I added the Nulon lfter quiet stuff which would work for another 10,,000K's.
It's worth a try before to replace the tappets and spend a lot of $$$.
Also a good oil change may help at the same time.
It's a common problem with these motors so your not alone.
I just luv my "clacker Jabber"
If I recall correctly, the procedure is to have engine at operating temperature. Hold the revs at 3k for 20 seconds, then idle for 20 seconds, rev to 3k for 20, then idle. Repeat about 10 times and then go for a drive.
This should flush any crud out of the lifter. Best to be done with fresh oil, also if you change fluid every 5k you wont get the very often if at all.
We have the DOHC, with 260k on the clock, never opened and there is no ticking due to good servicing.
This should flush any crud out of the lifter. Best to be done with fresh oil, also if you change fluid every 5k you wont get the very often if at all.
We have the DOHC, with 260k on the clock, never opened and there is no ticking due to good servicing.
Who is online
Users browsing this forum: No registered users and 13 guests